Jump to content
SAU Community

Recommended Posts

Hi , I'm looking for some help/advice.

I finally got around to putting coilovers in my bnr34 and was wondering what ride height others are running?

I have them at fairly even heights front and rear atm.

Any help would be awesome! Btw I have 19 rims.

Thanks :)

Link to comment
https://www.sau.com.au/forums/topic/439337-r34-gtr-ride-height-help/
Share on other sites

Rims make no difference, but rolling diameter must be the same within a few percent to be legal and to make sure your speedo is accurate.

IIRC all GTRs are the same with respect to hights (but i'm not 100% sure). So you want lowest of 350mm front 340mm rear (wheel centerline to guard). If you want higher, say if you have clearance problems under the car, then just make sure the front measurement is 10mm higher than the rear.

If you're going to track it, get it corner weighted after you've settled on the height you'll run.

You want the least amount of neg camber on the rear that works. So the usual range is about -0.75° to -1.0°. That tends to give the sort of compromise between straightline grip, tyre wear on the inside edge and cornering grip for a street car. A stiffly sprung track car on sticky tyres might want to run a lot more camber.

The same rules apply at the front but you can run a little more camber. Up to -1.5° is the normal range. But again, your mileage may vary, depending on how the car is used, the tyres, etc.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • IMG_8641.mov     She doesn’t sound the best but starts with out using any gas now. I just ran some injector cleaner through her. started roughly the first time after adding it but gave it the beans slowly upto 4k, Must have cleaned a few cobwebs out. another step in the right direction for the sub
    • Sadly I can confirm if you are actually seeking to drift, you will quite easily spin up one wheel. Even if you're going in a straight line. I am not entirely sure of the metrics/terminology here but there's only a certain amount that the helical will actually spin both wheels. I've seen it on video with my own car where two lines of smoke switch over to just one after you really get in to it. Unlike with a clutch diff where you can keep your foot planted until the car regains grip, in my experience with the helical you want to be utilizing traction control allowing LIMITED slip or lifting (partially) when you start to spin up both tyres with a Nissan helical. Which makes them pretty sub optimal for drifting duty. That said... this is probably a helical on numbers alone. Just put the Kazz in
    • Let's just fix the problem by f**king the rest of the gearbox.
    • Unlikely, as per Greg's post. This is not helical diff behaviour unless one wheel is up off the ground. Shimming what? You don't "shim" a mechanical LSD. Probably not in the sense that you have heard of people "shimming" a diff. And the process that Nissan f**kwits call "shimming" a diff involves super-preloading a VLSD cartridge against the side of the diff to create a friction/wear point (in a place that it wasn't supposed to have one) to make the sloppy, useless, viscous diff into a hybrid viscous/mech abortion. In case it isn't clear, I consider the process to be stupid. Nike.
    • How much does the shifter move when the car is in gear with the engine off? If it is more than about 1cm you need to replace your shifter bush. Your shifts will just get crunchier, not faster, with a short shifter unless you also rebuild the whole box
×
×
  • Create New...