Jump to content
SAU Community

Recommended Posts

Hey guys, pod on my car is currently sitting near wheel arch... I know... I know... I bought it like that and have a pipe being made up to be able to sit it up top again. But anyway, I was driving home from work tonight, and it began to rain, I didn't go through puddles or anything remotely close to it, but the water from the rain was causing the car to drive pretty, then it also stalled out a couple of times. Could this effect my engine in anyway? as I said, the pod was at no point fully submerged in water or even close to it. But if it was sucking in the rain water, can that cause any damage to my engine.

I don't drive at all when its raining, its just tonight it decided to start raining while I was driving home from work -_- really hope I haven't caused any damage.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/
Share on other sites

My cold air intake draws from in front of the passenger's wheel. Not one drop of water goes up into the factory airbox from there. A pod hung in that location should also be fine.

A wet pod filter or wet AFM will generally cause trouble though. Did you feel the pod to see how wet it got?

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207690
Share on other sites

When I had my XR6 Turbo with pod in the guard I sucked a lot of water in one day and the car stalled. I got all the water out and let it sit over night.

I started it the next day and it ran a little rough but eventually dried up.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207699
Share on other sites

Unless you hit a big puddle and water splashes hard you wont notice any problems and even if you do and abit of wAter goes into the afm you might start to have a missfire but will go away once it dries up.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207700
Share on other sites

Yeah true. One of my friends had the same problem, but he unfortunately went through a puddle, and the whole pod was submerged in water and sucked a shitload in. Blew his engine two weeks later. So the main thing im asking is, as long as the pods not fully submerged, a little bit of water isn't going to effect the engine? I plan on fixing this asap just for peace of mind lol. The rain wasn't real hard, but it was causing the car to stall out a couple, sitting on the side of the road starting my car a couple times wasn't fun haha.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207971
Share on other sites

Is there a way of checking these things or? sorry guys, Im pretty paranoid about keeping my car healthy, going to uni atm and dont have the dollars for a new rebuild But I love my skyline too much to sell it. Would checking the oil for milky deposits be a good indication whether water has gotten that far? I know that im probably just being paranoid.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7207999
Share on other sites

If you're that paranoid, just take out the cooler and let it drip into a container and check the oil that comes out of it. depending on your setup, cover the hole that the old smic has left, and make a cover for the pod blocking off the headlight etc... Put the standard airbox back in.

But really you're just being paranoid. ;) Just don't flog it when it rains, and steer away from puddles.

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7208009
Share on other sites

If water was to do any damage, it would be done by now. If you car drives and runs, then its ok I'd say.

If you paranoid about driving in the rain either get a stock airbox or possible make a shield for relocate the pod...

Link to comment
https://www.sau.com.au/forums/topic/439570-water-and-pods/#findComment-7208044
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • How old is the battery, it's more likely your battery is on its way out.
    • I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...