32 Sterio Install Need Help!

[Jake_32gtst]

Hey guys, iv done a few sterio installs in my time so I'm a bit confused..

I'm trying to install a pioneer headdeck into my 32 gtst.

Now I went to repco and got the quick loom chopped it and wired into the pioneers loom..

Plug into the 32's factory loom and I get nothing..

The rear speaker have been run too the headdeck by the previous owner so I don't need to use the plug from the factory loom..

I have a orange cable sitting behind my deck with a tag on it covered in Japanese does this need to go into the sterio harness with the orange illumination cable??

I also have another two plugs (one black, one yellow) that are next too the sterio plugs.. Do I need to use these aswell???

The Car came as is with a crap old deck that wasn't wired in...

Pictures below.

Please help

[junkie]

Where is your earth cable connected? I always extend mine and connect them to the metal frame under the dash, under a nearby screw. As far as I remember hooking earth to the factory loom was always troublesome

[Chris Rogers]

There has been a ken wood cd changer and radio in there.

Make sure the ground goes to frame and that you have not got any blown fuses.

[niZmO_Man]

Find battery and ignition wires with a multimeter/similar and run the rest yourself. That's what I usually do.

[Jake_32gtst]

Iv got power to the deck but my deck isn't turning on.. I can only assume it has something to do with the orange cable sitting behind my headdeck (in pic above) or the other yellow plug as it has the same coloured cables that the large yellow plug has.. the rest of the loom is wired correctly although I haven't run a ground as of yet.. Fuses are not blown.. I put the headdeck in my glxr and it worked fine..

I got the loom adaptor from repco so it's just plug and play so I do t understand why it's isn't working..

Does anybody know what those other two plugs are and what that orange cable is??

[Jake_32gtst]

Thanks for the help so far btw..

[Jake_32gtst]

When I say power to the deck I put a multi on the loom before I plugged the deck in

[Jake_32gtst]

If someone could take a picture of there's and post it that'd be awesome..

[Jake_32gtst]

Multi on everything all has power.. I'm pretty sure my headdeck is ground sensitive so basically it won't turn on at all unless it has a decent ground.. In the previous deck the ground it didn't matter lol

[Jake_32gtst]

If someone has a pic of what they did can they please upload.. Tried to ground it didn't work

[Chris Rogers]

4 plugs

Blk - hand controls top of dash

4 pin -accessory plug

6 pin - rear spk with amplifier

12pin - main plug with front spk and main/key/antenna amp.

[Jake_32gtst]

Thanks mate..

Iv figured out the problem..

Got a decent multi and the I only had 6v at the yellow battery active.. Previous owner taped into the wrong supply and the headdeck obviously wasn't getting the correct voltage..

Thanks for the help..