Fs: [Vic] Td06 20G 8Cm/manifold/trust 50Mm/dump $1.5K

td06

By John.O,
March 22, 2014 in For Sale (Private Car Parts and Accessories)

https://www.sau.com.au/forums/topic/440892-fs-vic-td06-20g-8cmmanifoldtrust-50mmdump-15k/

Followers 0

Recommended Posts

John.O

Posted March 22, 2014

- Share

Posted March 22, 2014

F/S: TD06 20g 8cm Vband (rebuilt by MTQ less than 3,xxxkz)
Stainless steel manifold, low mount (unknown make)
rear housing has been welded to manifold... don't ask, works perfectly fine none the less
Trust 50mm Wastegate
3" vband dump pipe
Oil & water lines included
Setup has made 250rwkw at 16psi
Awesome upgrade for RB20!

reason for selling I'm building a new engine & i have found my bigger setup i'm looking at buying
Chasing $1,500 Located W.Suburbs of Melbourne

Link to comment

https://www.sau.com.au/forums/topic/440892-fs-vic-td06-20g-8cmmanifoldtrust-50mmdump-15k/

Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign in

Already have an account? Sign in here.

https://www.sau.com.au/forums/topic/440892-fs-vic-td06-20g-8cmmanifoldtrust-50mmdump-15k/

Followers 0

Go to topic listing

Announcements

Latest Posts
- How "plug and play" is the Haltech Pro for R33 GTST
  
  By Dose Pipe Sutututu · Posted 50 minutes ago
  
  And that's great, perfect for your USDM and ADM fuel. The off boost area of the map is defined very well, when compared to other manufacturers.
- How much roughly to convert stock r32gtr to single high mount turbo + ecu and tune
  
  By thejacksta88 · Posted 1 hour ago
  
  So guys I'm thinking I'll go 6boost manifold gt35-900 50mm waste gate full exhaust Haltech platinum pro Walbro 255 do I need to upgrade coil packs and would anyone suggest drop in cams ?
- How "plug and play" is the Haltech Pro for R33 GTST
  
  By joshuaho96 · Posted 1 hour ago
  
  I know it'll run, but from what I've seen the Haltech base map is actually quite a bit more conservative than the OEM stock map.
- Need help/advice with bearing taper clearance, eccentricity and arp studs.
  
  By r32-25t · Posted 1 hour ago
  
  They have to machine the tunnel with the arp studs in because they change the clearance compared to the factory bolts
- Need help/advice with bearing taper clearance, eccentricity and arp studs.
  
  By Desean Strickland · Posted 2 hours ago
  
  Thanks for the response. I get why line boring the block could cause issues with a spline drive oil pump but I’m just using an extended flat drive collar, u reccon it could still cause issues?

Sign In

Fs: [Vic] Td06 20G 8Cm/manifold/trust 50Mm/dump $1.5K

Recommended Posts

John.O

Link to comment

Share on other sites

Create an account or sign in to comment

Create an account

Sign in

Announcements

Latest Posts

Forums

Activity