Turbo Inlet Elbow For Gt35R

[danny14]

Hey guys anyone know ofsome good fabricators in perth area.

What have you done to plumb your pod in on single turbo setup on 26 . I have always run twin turbos so this is new to me

Ps

Im not running mafs only need single pipe

[scotty nm35]

Not much to it, just a tight 4 inch bend would do, with a straight section after the bend.

If you run into issues finding someone local, I can fabricate from pictures. Are you running the BOV/breather back at all?

[danny14]

Well thats another thing I need to figure out where to run the bov pipe do I have to run that into the turbo intake ...

[scotty nm35]

Are you running an afm? If you are just MAP sensored then no, it doesn't have to plumb back. (Unless you want to try and make it slightly stock looking, if only a little.)

[danny14]

Ha ha no running map man . So that pipe that goes to bov where does thst have to run into pressure side then vent to atmosphere

[SiR_RB]

I've just got a 4" 90degree mandrel bend pipe cut to size,

Made a hole and welded a flange on it so the bovs recirculate as per factory

Nothing to it realy

[danny14]

I've just got a 4" 90degree mandrel bend pipe cut to size,

Made a hole and welded a flange on it so the bovs recirculate as per factory

Nothing to it realy

Would you be able to give me dimemsions so I can get the boily to make me one at work .-)

[SiR_RB]

Depends what manifold you got and the position of the turbo

90degree worked for me, I've seen others use 45degree also

[danny14]

I will be running 6 boost.

[iruvyouskyrine]

I will be running 6 boost.

That doesn't mean anything, you are still able to position the turbo as you need. Search "turbo clocking"