Jump to content
SAU Community

Recommended Posts

Unless you get a stock turbo for almost free, I don't think its worth taking the risk on a old stock turbo. You may consider having one rebuilt by a turbo workshop like hypergear. They have a "R33 standard profile high flow" which has much better flow through the higher rev range, but more lag. It will produce boost from 2.8 - 3k rpm. You can ask to see if they can do a version with characteristics closer to stock.

With all the effort it takes to strip down the area and take off the turbo, it is wise to do a thorough job once over while you are there. Ie, rebuilt turbo, change manifold studs and gaskets, inspect for cracked metal etc.

I did all of that for less than $1200. I used the standard profile high flow from hypergear, though if I were to do it again, I would probably see if they could do a version closer to stock.

  • 2 weeks later...

Hi

I started to remove the turbo and I found a heap of oil in the pipes.....

and I have about 3mm end play in the turbo....

I need a cheap stock turbo......

I only want to sell the car

regards robyn

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The powder coating came in at $250 EACH. The TRX rims got a coat of clearcoat on the outside only.    
    • Bit wet, but YUMMY
    • Keeping in mind that I am currently getting flat 10 L/100km on my RB25DET, which means >>500km/tank. I would test this car for vacuum leaks, check codes and AFM signal with NissDataScan as D says, check plugs, do a compression check while they are out.
    • It is hard to be specific half way across the world...but it *seems* like it might have a minor issue. Is the idle stable and does it rev smoothly? I would not expect any pops out of what I am assuming is a standard ECU, standard tune, standard exhaust. You can use Nissan Data Scan to find out exactly what is happening when it runs, the cable/software is reasonably affordable if you are not planning on changing the ECU (which hopefully you are not with an NA skyline) BTW your mileage may not be that far off, these are heavy old tech cars, and being NA might mean you use a heavy foot to keep up with traffic....
    • Hey guys! Y'all are the masters so figured I'd check in on a few items here. - My engine sounds ever-so-slightly more raspy than the other NA RB25s I've listened to. It's barely noticeable but definitely a slightly different sound. - When I back off the throttle at high RPM, I will sometimes get a pop out of the exhaust, assuming this can be diagnosed as misfire. Some history on the car: - Had an exhaust leak in auction sheet but was claimed to be fixed by seller (bought from USA importer).  - Car's coil packs and sparks were replaced when it was sold to me, but unsure on what the gap is and whether the coil packs are correct.  - A prior mechanic had misdiagnosed a pilot or throwout bearing sound as LSPI/detonation. Had played with timing a bit, pops/raspy sound of engine just got worse. Got timing reset. - Had failed emissions a few times. First time went in as is, failed. Second time, replaced cat, still failed, running rich as hell. Third time replaced o2 sensor, passed. Car still smells gassy though. - Timing belt and valve cover gasket also replaced.  - Gas mileage is... low. about 350-400K per tank.  Any idea if I'm having any serious issues here or does this all sound like normal old NA RB stuff and I'm fine to drive it with the pops/slightly raspy engine? If it'll help, I can get drop a video of the sound of the engine.
×
×
  • Create New...