Jump to content
SAU Community

Recommended Posts

Don't listen to them.

Yeh man, you need to run a boost line to the manifold, it will work, and may even measure boost if your cold air induction is working well. You just need to drive really fast then turn the key off. ;)

  • Like 1

Get some fishing line (preferably thicker shit so it doesn't snap) and tie one end to the needle of the boost gauge and the other to your accelerator pedal. When you push the accelerator pedal down the needle will rise. Easy 20HP gain, and an extra 3k resale.

Haha dont bother man there is nothing to monitor. Theres no purpose, so why put it? You're gonna have to explain to every person that hops in your car why you installed a boost gauge in a n/a :P

You could hook it up to the vacuum line as suggested, but its a boost gauge which reads positive pressure, vacuum is the negative boost pressure. Unless you plan on running nitrous oxide, its completely pointless. Just sell it and buy some petrol (:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Sell it and buy something newer? 😛
    • Better then PooPooG... or is it PeePeeG? 
    • The steering wheel on my 97 s3 gtr is a little bit worn out, so im on the hunt for something mint. I notice that this type of steering wheel is on several other nissan's of the era.  Does anyone know if their all identical, or are there slight differences? I feel like gtr tax applies to anyone selling one, but if it comes from any other car the price is much less, even though its the same design.  Chat gpt says the material for the gtr is slightly different and it says gtr on the wheel, but every pic ive seen it just says nissan. 
    • I might have to say it.
    • Ahh... it's an early RE5R01A box, that means the pinouts I gave are wrong (they were for the RE4R01A 4-speed box)... I'll have to dig around in my docs to see if I've got that schematic (they used the same gearbox plug, with the vacant pin wired to the direct drive clutch solenoid)...prolly hidden away in a supplement somewhere... ...there were 3 variants of the RE5R01A ~ this early schema was what we called the 'dumb' 5 speed ; it's what jatco called a 'medium duty' box, with torque holding up roughly ~200ft/lbs or so, which was good for NA from RB20/25DE and up to around VG30 output spec. With the RB25DET (and VG33/35 mills), the only options they had was the 4-speed 4AX00 box, which had been beefed up to handle the extra torque (primarily for the VG35, but it also suited the RB25DET mill and others)...and the RE4R03 box in large 4WDs a lot of the time... ...the next variant of 5-speed was redesigned, stronger, and 'smart'...first ones had external TCU with internal (on valvebody) Shift Control Unit, pressure switches, and 2 x TSS...and the last ones had internal TCU+SCU setup, with CANbus control etc etc. @DRoc81 On the RHS of the box towards the rear, there should be a stamped silver ID tag -- what's the model number? Oh...and with the early 5-speeds, the torque converter control solenoid assembly should be replaced as well (31940-60X00)...it's a bit Murphy's Law ....if one has failed, bet on the rest not being far behind ...
×
×
  • Create New...