Jump to content
SAU Community

Recommended Posts

will be surprised if mine pop,im pretty fussy about double checking all clamps and i dont use shit radiator clamps like some people out there,got to use the good bolt down clamps.

finished the pipe work and test run car and all seems ok,double checked the clamps and the car seems to sound and go a bit better as inlet pipe now not getting heat soaked so will see how it all goes tomorrow.So who else is going from the club?

it was wet but sooo much fun,had the skyline drifting sideways through most corners and a good bunch of guys to run with,would like to thank qeo for a great event and hopefully more skylines turn up next time,and no popping off of my intercooler pipes and they are so much better than before,the intake pipe now only gets warm not roasting so return flow setup works a treat.

  • Like 1

yeh was pretty good,had an 86,gto mitsi,an audi tt,subaru legacy,evo 5,6,8 and 10,oh thats right there was one two toned skyline that was sliding around everywhere,whore of a thing,was shaking its arse to all the evos.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh... literally every time i jump on a forum, see an instagram post or see an engine bay at a car show, i get an idea and add it to my 'to do' list. So what started off as, hey can u just make a couple of intake hard pipes because my dumbass bought the wrong apexi kit, blew out into a 2 week job including braided brake lines & custom bash kit for the front lip haha.  Getting Luke from A4E engineering to make a full custom exhaust with a controllable aes dump valve so i can actually switch between quiet and loud, because right now its just loud all day every day. Then after that go and get the tune redone flex e85 & 98 as i get bugger all milage from e85, makes going for longer drivers difficult
    • Car looks clean as. You ended up getting quite a bit done 😂  So what's the plan for the exhaust? 
    • The only Neo rods that were any different to any other RB25 rods were the DET ones, and they were the same as RB26. Here is a Neo DET rod. O5U part number visible. Here is a post in a thread here on SAU with evidence from someone who has done this before. There are photos in the thread of normal RB25 rods.  
    • Sure, but why assume that will be the case forever? And why assume you'll be able to do an oil change to swap back to a stock drain bolt before that happens? And does it even matter when I change the oil at fairly short intervals? Life can be funny sometimes and unexpected things can happen. Like breaking a collarbone so you can't do any work on your car for a few months but the oil change is due so you have to take it to somewhere and hope they don't do something stupid like stacking the new drain plug washer on top of the old one.
    • Do u know how to identify the rods are rb25 or neo ones? Can u look into the pics and tell me is they de or de neo ones. Its confusing becoz my motor has de neo head but block is 25de 75t, so really confusing me about rods, crank.
×
×
  • Create New...