Silicone Joiners For Fmic

[Pr0x1mity]

I measured the piping outside and it comes up as pretty much dead on 60mm. I've been looking and have found 57mm and 63mm joiners.

Do I go for the slightly larger and then clamp it tight? Or stretch fit 57mm as well as clamping.

FMIC noob here.

[Blackkers]

57mm is 2.25 inch

63 is 2.5inch

the pipe is most likely not 60mm to be honest, it's not a standard size. measure again and note if the pipes have a lip on the end of them or not

[gtr jet]

Would most likely be 63mm.

[89CAL]

What did you measure with? Verniers are really the only thing I'd use for an accurate measurement

[scotty nm35]

Jap piping is metric, it will most likely be 60mm.

I can supply most metric sizes (and metric to imperial) if you need something in particular. Otherwise heat the smaller size silicone in boiling water and slide it over.