Jump to content
SAU Community

Recommended Posts

Last night as i was driving home from work my r33 began to run wierd

First when i pushed the accelerator nothing would happen and it was very temporary and a second later of pushing harder it would be back to normal. This occured a few times and few of those times i shifted to a gear below and it went fine.

Then later it completely gave up and the engine pretty much turned off (lucky i was on the left lane and put hazards on). Restarted the car and again a few times seemed to struggle to accelerate but ended up going and i drove home with a few temporary loss of power.

This morning i drive into work and no issues at all.

Any ideas?

Was thinking coil packs? but no conisistant misfiring etc

Fuel? My exhuast does have a massive hole in the axleback if thats mucking around with AFR?

Link to comment
https://www.sau.com.au/forums/topic/446835-r33-gtst-running-wierd/
Share on other sites

your exhaust wont be causing issues with your afr's. Get some CRC contact spray and afm spray. clean your plug and pins for the afm and clean inside the afm with the afm cleaner spray. Give that a shot first before anything

I think similar thing happen to me, it was the o2 sensor, because I bought an aftermarket o2 sensor without plug, so I had to join the wires up and I just taped it, and problems occurred. But it seems to be fine once I've soldered the wires.

So maybe check your o2 sensor?

  • 4 weeks later...

sorry been a while as ive been busy with other things (r33 is barely driven)

Changed the spark plugs over the weekend. Didnt look too bad but prob was best to change them. Coil packs are confirmed to be spitfires and are in good visible condition. Did manage to snap a coilpack clip (still clipped in but will get a new coilpack harness to sort that).

Drove the car after - drove ok for 10 mins, then started spluttering and after a while pretty much lost all power. had to fight with it to and after a while able to run around 2000rpm. Took it back home, but when 2 min before i got home, it started driving normally.

Also the day before i changed the spark plugs i tried starting and it struggled first few times but started after a while.

My belief is fuel (though im barely an expert)

Theres fuel in the tank

Fuel filter was changed at last service (around 1500ks ago)

So if it is fuel my guess is the following

Fuel pump?

Fuel lines?

Fuel tank?

Injectors?

Any idea how to check/test them

or any other ideas on whats causing this?

  • 2 weeks later...

seems like an intermittent problem, is the earth point from the battery on properly and is the point clean?

is the fuel pump earth hard wired?

if you can get your hands on a fuel pressure tester then having a look at that would be an ace idea. If its spluttering and you have good coils, good plugs n fuel, it may be fuel pump related but its hard to point at that (e-diagnosis)

hows the CAS set? it could be going into Rich n Retard.

Many factors

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • No intention of driving the car the way it's set up now, just wanting to make sure I haven't made any mistakes along the way so that the tune can go smoothly, I don't want to waste anyone's time with stupid issues. And of course I intend to get it towed to the dyno in a completed state 😅 I have the base fuel pressure with the vacuum disconnected set at about 40psi, which I believe is at least relatively close to stock fuel pressure, maybe I'll have a fiddle with the reg and see what happens. For all I know I could be wasting my time with this and I should just plumb it in and see what the tuner reckons. I just find it a bit strange that it seems to be under so much load just free revving, but maybe that's just a result of the turbo slowing down the exhaust gasses and making a restriction in the flow, with no boost to compensate.
    • The boy just hit up google translate and it worked a treat, he said step one was "please urinate with precision and elegance", he then sent me the correct translation  I get some new loctite for the small fixtures tomorrow and get some "dort" going after that 🤣
    • Right, so is the fuel pressure the same as it was previously? If not, well, it's not going to work well. I can understand the theory I assume you are going for, which is: "Run it N/A, and if I have the original AFM, and same amount of fuel and intake air as previously, the fact there's a turbo in my exhaust should still make it run" Which it... might? Provided you don't actually change how much air or fuel is going into the car.. or getting out. But if you have changed that, all bets are off. What is the purpose to even have the car run this way? To get it to a tuner? And if the goal is to limp it to a tuner, you're still going to what - plumb up a whole intercooler system and new intake in the parking lot out front before your tune......?
    • Haha yea it's a bit of a weird setup at the moment, just wanted to make sure I sorted out any headaches before dyno day. At the moment I've changed the exhaust manifold, turbo and downpipe, 460lph fuel pump and rising rate reg as well as the previously mentioned headstuds and gasket. The nistune was already mapped for the car as it was and drove around for a few months no worries. The plan is to run flex fuel hence the big pump, which I've wired direct to the battery through a relay to avoid voltage issues.
    • Um. Was the ECU the same as the one previously there? I know R33's needed R32 GTST ECU's or other tomfoolery to run Nistune. This is such a wild setup. Most people would plumb in the turbo then not drive the car (i.e tow it to a tuner). What's actually changed since it last ran?
×
×
  • Create New...