Jump to content
SAU Community

Recommended Posts

I know this topic has been beaten to death numerous times but I just wanted an experienced opinion on what weight of oil you guys would use in my car.

Its an r32 gtr 94 model with about 130k kms on the clock and no serious mods (basically stock). Now seeing as factory weight is 7.5-30, in your opinions would you guys go full syn 5w-30 or 10w40?

Link to comment
https://www.sau.com.au/forums/topic/447348-weight-of-oil-for-r32-gtr/
Share on other sites

As the engine wears the clearances get larger. To maintain decent oil pressure a thicker oil would be required.

Do you have an oil pressure gauge? How is the oil pressure now? If it's fine jeep using whatever you are using.

Yeh on the factory oil press gauge it sits about half way when driving and drops a bit on idle but I've heard that the factory one can be a bit dicky sometimes.

I think I will go the thicker then.

Also do you know of the sump capacity by any chance?

AFAIK the only good reasons to run a thicker than specified oil is to;

1. Return oil pressure to spec on a worn motor,

2. Provide a safety margin in a motor that is overheating the oil,

3. Make an engine run more quietly, however, higher noise does not appear to correspond to higher wear

I run Mobil 1 0W-40 in my Stagea daily and in my street, but tracked, GTR. IMO its a good bang for buck oil. In the stag its still good after 6000kms so ill try 7000kms and re-test this fill. I will test the GTR @5000kms next change.

On a stock motor a ?W-30 should be fine as long as the oil pressure is within spec.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Not much. It's barely more than an hour's labour. So that-ish plus a boot, clamp strap, some grease.   But, being an R32 GTR, when it is up in the air and the driveshaft is out, about $9k worth of other problems will become visible.
    • Yes, as above. The welding is an easy enough job. Proper reupholstering, perhaps less so. These, and pretty much all seats of the same era (and probably still) rely on molded foam parts to make the shapes. That foam is the yellow detritus visible in the photos. And it is difficult to replicate. I didn't want the pain, so went aftermarket seats instead. But for "saving a classic".... it's probably worth the kidney and left nut that a trimmer will want to redo them.
    • Way too accurate.... source: got flogged by an unsuspecting i30N last night... Super tidy looking 32 though, hopefully you find the time and funds to get it back on the road and enjoy it again!
    • Source: This thread, and the thread this thread spawned from. Alternative take: Is heat actually an issue for the use case of this vehicle? I wonder if it actually would be. Nekminit
    • Considering the price of GTR stuff now the answer is yes. That's a straight forward TIG or even MIG job. I'd put extra tubing inside, for extra strength and weld it up. Then use the spare seat as an example to get the bolster rails in the correct position and the re-apolster. If you don't mind me asking what did you pay for the pair as they are?
×
×
  • Create New...