Jump to content
SAU Community

Recommended Posts

Well if you are trying to market on SAU form, you will need to do what I did.

Send us your turbo and get it high flowed, :yes:

Get all supporting mods.

Then get your car tuned on P98 fuel with and without additive.

Post up your results that contains Power, Boost, Torque, AFR as well as your ignition advance table before and after.

If it did make more power by then, we would understand more about this product, what it does, and benefits in comparison to other alternatives.

I reckon you would see similar gains with an amount of e85 I the tank.

Just enough to lean off mixtures nicely. Maybe 5 bucks of e85 would do it. How's that compare to the ozygen?

i'm just sharing what I got from using someone's product...

Before and after additive, power, torque and AFR graphs are already shown. It works as advertised :)

no variables to confuse or mislead results. Stock ecu. So if you modified your car like getting your turbocharger high flowed...the improvement gains could be more... ;)

You did 20 dyno runs yes?

There is 20 variables right there.

Over the course of 20 pulls how much did the air temp change?

would dyno runs be considered as variables? or number of times of repeating the experiment to get consistent results so as to eliminate the outlying (is that what they are called?) data?

i have to say we did not monitor the intake air temp but right after the last run, oil temp was 91 deg, water temp was 81 deg, intake air temp was 28 deg.

You can't just dump in the additive to a stock car, print out the best results and assume it actually works.

if it does boost the octane level, especially for a turbocharged engine, lets say at 20psi of boost, by keeping the AFR constant, you will be able to add in extra degrees of ignition advance without gain knock. just like as if you are using E85 or C15 fuel.

That extra power made by additional ignition advance will be the differences in fuel advantage.

  • Like 1

If the fuel is more oxygenated it will make more power, few things you could answer are how much does it cost and why not just tune your car on 98, drain it, then retune on that fuel and see the increase?

You can't just dump in the additive to a stock car, print out the best results and assume it actually works.

why not? pardon my questioning but car is currently stock... so all things equal, adding this product gave me 3% increase overall....doesnt that mean that it works? if i used a modified car, disbelievers will then say that maybe the car's timing, fuelling etc was modified inbetween runs. In my situation... nothing was touched, nothing can be adjusted cos it was a stock ECU. So isnt that's fair testing?

print out best results? would a stock car give such varying results over 20 runs? if nothing is changed....would a worst run and a best run have such huge difference?

If the fuel is more oxygenated it will make more power, few things you could answer are how much does it cost and why not just tune your car on 98, drain it, then retune on that fuel and see the increase?

based on what I know,...its retailing at $60 for a 1 litre can and that can treat up to 65 litres.

why not tune my car on 98 drain it then retune? would love to but my car is stock...will do it again when i have all my mods but time and money are the deciding factors...

plus.. if i did that... wouldn't people then attribute the performance increase to the tune and not the race fuel?

Although having said that, my friend has dyno graphs of R35s on normal 98 without tuning compared to tune+additive.... and the increase is even more.

But if people are already skeptical of 3% increase in a stock car... would they accept a 18.8% improvement?

Hasn't it already been discussed that the small power increase may be due to the tune being leaner (as there is oxygen in the fuel, resulting in more air:less fuel AFR due to injecting the same amount pump fuel vs fuel with additive?)

The initial dyno graph has thrown me a bit though, it looks to me like the AFR's were richer with the additive when it made more power. I might have to go back and have a look but this doesnt make sense to me if it is the case. Octane booster shouldnt change the AFR, just make it possible to run more timing

I'm sorry to join the sceptical people in here, but I can't see the power gain (if it can be proven to be worthwhile) being worth $60 a tank. UNLESS it ends up being as benefical as E85, but I remain sceptical

why not? pardon my questioning but car is currently stock... so all things equal, adding this product gave me 3% increase overall....doesnt that mean that it works? if i used a modified car, disbelievers will then say that maybe the car's timing, fuelling etc was modified inbetween runs. In my situation... nothing was touched, nothing can be adjusted cos it was a stock ECU. So isnt that's fair testing?

print out best results? would a stock car give such varying results over 20 runs? if nothing is changed....would a worst run and a best run have such huge difference?

based on what I know,...its retailing at $60 for a 1 litre can and that can treat up to 65 litres.

why not tune my car on 98 drain it then retune? would love to but my car is stock...will do it again when i have all my mods but time and money are the deciding factors...

plus.. if i did that... wouldn't people then attribute the performance increase to the tune and not the race fuel?

Although having said that, my friend has dyno graphs of R35s on normal 98 without tuning compared to tune+additive.... and the increase is even more.

But if people are already skeptical of 3% increase in a stock car... would they accept a 18.8% improvement?

You don't seem to understand what i'm saying, tune your car as hard as you can on 98, then do the same on the additive. If this fuel is so much better you will be able to advance the ignition over regular 98. The whole point of a "better fuel" is to be able to run more ignition advance over regular fuel. Note the changes that it allows you to make(boost/timing/afr) and post here again, instead of just putting into a stock car. I could run E85 in a stock car and it would make shit for power if i could even get it to start on a stock tune, but we all know it would make loads more tuned properly for the fuel.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • They see me rollin' they hatin'....... Took me most of the day to make the necessary mods to the mounts to make them fit the car.  Fortunately I was able to just use the mounts that came with the rotisserie. The rear ones are really secure, the front I feel i might reinforce a bit more as it doesn't seem like enough attachment to the vehicle. I'm sure it's fine but better to be safe than (extremely...) sorry.  I drilled and tapped thread into additional M12 holes to each car mount where it attaches to the rotisserie as an extra fail-safe. Without them the side to side movement is just restricted by the allen head pinch bolts, nothing actually goes though the beam. Does now! I still need to adjust the rotisserie to get the car centred in terms of centre of gravity. If it's too high or too low relative to the rotational centre line of the car, it will be like a turtle and roll onto its back or as it currently sits, I dont think I'd be able to rotate it as it sits as it needs to lift the whole car up as it rotates. Ain't happening... I'm going to be nervous as hell the first time I go to spin it on its side...    
    • Oh yes done this when the window started flopping around.  Turns out the guides that run along the rail chanel had crumbed way. Took off the door card and pulled out the window mech, then the window, which you have to pull out through the top. As said unbolt the guide rail and don't spend 30 minutes getting frustrated trying to find a way to slide it out upwards cause that don't frigging work. Drop it down and out through the door hole. All I did to repair it was slice some 10mm clear plastic tube, vertically, then screw it to the guide rail both sides. This tubing rolls inward on both sides and leaves a gap wide enough to hold the window. To finish all I did was lube the plastic tube with olive oil and Bob's your uncle . . . well if he has the operation he can be your Aunt ! !  10 bucks in plastic tube and another 5 minute job done again . . . . YEH BULLSH#T ! My love for Skylines knows no bounds !
    • So was there a solution to this problem? I’m having this issue now. 
    • not expensive, just irreplaceable if you don't go sub 60 at wakie in that thing people will start talking
    • I haven't replaced that, but I have had the doors apart on the r32 a couple of times The door skin will be held on by a combination of clips and bolts, just take it slowly and make sure all the sneaky hidden bolts are out Once the skin is off you should be able to pop that piece off pretty easily, looks like there are only 2 bolts holding it on
×
×
  • Create New...