Jump to content
SAU Community

Recommended Posts

There is the potential it will destroy your engine too.

Why not just buy a Hypergear? Cheap, high quality thrust/bearings, properly balanced, with local warranty. I try and back the Aussie made products if I can... No way I would want to push an Egay gt35 to 150,000 revs. ;)

Ive seen the vid of a t70 the compressor wheel was no bigger than a t04 just with a big ass housing on it. Its what its labled as anyway so no doubt its a mix match or smaller than a genuine garrett. Getting it balanced and good seals put in if it blows it blows

why would you buy a dim sim special turbo, re balance it and re seal it, etc.. it will end up costing as much as a proper turbo to begin with.. if you're really keen on ling long special turbos at least go with a Kando peking duck special.

And will do ben lol I had no issues with the ebay 38mm gate I used on my v8

A wastegate is something i consider you might get away with, as per your experience. Not worth the risk in my opinion if it sticks shut.

Also, it doesn't spin at 100,000 rpm. ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Apexi SAFC - AFC 1st Generation Rare Old School JDM As you can see it all lights up in the photos and is in 100% working condition. Has been kept in storage and boxed for years there won’t be to many like this if any! Especially with all original packaging and manual. price:$650   APEXi SAFC 2  In Complete Working Condition Refer To Photos and view the video provided.  Price:$500   Located Melbourne - Australia Wide Postage Available At Buyers Expense  IMG_6981.mov
    • wow so i just logged back in after buying the 33 and joining SAU, And I've got all a whole bunch of you wanting to know more, well unfortunately it still doesn't run i was hoping it was seized from a snapped timing belt as i turned it over by hand and it was fine and then it did a few revolutions and jammed solid when i was running it with the key, so the timing belt is mint, I've also found a lot of the parts I'm removing have already got bolts undone or not quiet tight enough to be unsuspicious. so the plan is to find a running RB30 block and chuck my head on it.  I have a habit of buying stuff I don't need or require so for my none running engine i have a forward facing plenum , Apexi power fc, 40mm Turbosmart wastegate, And for the car its self coilovers ,low seat rails and BRZ seats (black seats with red stitching i already had these and they are ADR Approved and allow rear passengers access)  
    • I took apart the dash and found this strange 2 pin connector. it dosen't seem like its factory or oem, any clue on why someone would add it and where it might have been connected too?    
    • Not mention a SS2 especially with that rear oddly small rear housing. I feel the Facebook mechanics and experts has led OP in the wrong direction.
    • Won't get near 400kw, pump and injectors nowhere big enough. Bin the manifold and get off the shelf and a modern ECU.
×
×
  • Create New...