Jump to content
SAU Community

Recommended Posts

I have a turbo up for sale as i have decided to go with a different turbo setup.

HKS T51R SPL Ball Bearing V-Band

T62R Front Wheel & Internals

1.00 A/R

Ceramic Coated

HKS Manifold

HKS 60mm Wastegate

Located in Melbourne

$5000 ono

Link to comment
https://www.sau.com.au/forums/topic/449677-hks-t51r-spl-bb/
Share on other sites

  • 2 weeks later...
  • 4 weeks later...

Decided to sell, listening to offers, the turbo can be viewed at Edge motorworks for Melb people.

Also forgot to mention that the turbo is twin scroll + manifold.

Edited by Tyranus
Link to comment
https://www.sau.com.au/forums/topic/449677-hks-t51r-spl-bb/#findComment-7430700
Share on other sites

I would prefer to sell this is a whole kit. Like i said before im not desperate to sell but i do want it gone. If this does not sell i will send you a PM in regards to the manifold + wastegate.

Link to comment
https://www.sau.com.au/forums/topic/449677-hks-t51r-spl-bb/#findComment-7431981
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey everyone,   I’m looking for some advice on replacing the timing belt on my RB25DET Neo-powered 1998 Skyline. The engine was fully built about five years ago, including a fresh timing belt, water pump, and other essentials. However, since then, the car has only covered around 2,000–3,000 miles. It’s currently making around 650hp.   Even though the mileage is low, I know timing belts have a time-based lifespan too, and most recommendations suggest changing them every five to six years or 50,000 miles. Since I’m at that time mark, I’d rather not take any risks and plan to swap it out soon.   A few things I’d like to hear opinions on: 1. What’s the best belt for this setup? Should I go with an OEM Nissan belt, or is the HKS fine-tune a better choice given the power level? 2. Would you bother replacing the idler pulley and tensioner at the same time, or only if they show wear? 3. When swapping the belt, is it necessary to lock the cam and crank gears in place, or is lining up the timing marks enough? I’ve seen different approaches, and I want to make sure I do it right.   The water pump was changed with the rebuild and isn’t run off the timing belt, so I don’t see a need to replace it again. I just want to make sure I approach this the right way.   Any insight would be much appreciated. Thanks!
    • How does this compare to the internally gated g25-550 in terms of power production at same psi and spool
    • Did you find that your voltage of the battery wasn't where it's normally supposed to be? for example on my r34, it's at 14.5v when running after a few seconds, but I noticed when I had a rough start and it initially wasn't idling correctly, the voltage on my triple gauge cluster was showing lower than usual. Seems like the alternator is starting to crap itself
    • And, given that you're in NC, go buy an LS7 or something equally sweet and piss that crappy old RB off. Or call up Wesley Kagan and get his help putting a Merc V12 into it.
    • Do a compression test, and a bore scope on the cylinder that lost parts of the plug. Chances are, that cylinder isn't so happy anymore...
×
×
  • Create New...