Jump to content
SAU Community

Recommended Posts

Hey guys. So basically I was driving around and stopped at a set of lights and suddenly smoke vapour appeared out of my steering column (the plastic surround) this happened a few weeks ago once and just recently it happened again.

My indicator works but as soon as the flashing arrow is off I can still hear the indicating noise! Could this be the reason why there was a bit of smoke? A fuse screwed up? The car is a r33 gts25. The car has been driving fine and all other electronics work, the car also has an alarm system that utilizes the indicator bulbs when you lock and unlock the car, could this be another reason? Many thanks.

Edited by TommyR33

Take off the steering column covers. (Couple screws, piece of piss)

Look around all your wiring looms. Especially places where splices have been made.

The biggest give away is electrical tape. All the wiring is pretty well in your face once the covers come off.

The smoke may be coming from further down in your footwell and the smoke is just making its path up and away out of your steering column section

When you say you can still hear the indicator noise is that permanantly or stays on for a little while?

It definitely sounds electrical. Do you have an aftermarket turbo timer in the car?

Has the person who installed the car alarm made proper electrical terminations or just twist a twist and tape job.

It probably wouldnt hurt to double check all your fuses too.

More of a look and discover type thing really. With any electrical fault be careful though. No one likes shorting out wires and blowing up the pcb to your mongoose alarm hahaha

Take off the steering column covers. (Couple screws, piece of piss)

Look around all your wiring looms. Especially places where splices have been made.

The biggest give away is electrical tape. All the wiring is pretty well in your face once the covers come off.

The smoke may be coming from further down in your footwell and the smoke is just making its path up and away out of your steering column section

When you say you can still hear the indicator noise is that permanantly or stays on for a little while?

It definitely sounds electrical. Do you have an aftermarket turbo timer in the car?

Has the person who installed the car alarm made proper electrical terminations or just twist a twist and tape job.

It probably wouldnt hurt to double check all your fuses too.

More of a look and discover type thing really. With any electrical fault be careful though. No one likes shorting out wires and blowing up the pcb to your mongoose alarm hahaha

Thanks so much for the help! Basically what happens is I indicate and when it switches off the ticking sound stays on and almost at a faster rate of interval ticks. I went under near the footwell and fiddlled around with the plug that goes into the indicator box and now its stopped and is fine! I am no auto electrician Mick but there is electrical tape in many spots and some wires and plugs bunched up not connected into anything, I mean it all looks neat but yeah. Maybe get a auto electrician to have a look for me.

I had this exact issue on my '94 Bluebird.

Turned out to be inside the stalk, a small piece of plastic between 2 copper terminals had broken / melted so it was arching between them.

A small ziptie strategically positioned and trimmed down, with a spot of superglue on it, Fixed it better than new. :)

All good mate, happy to help. If you do decide to look into any connection further please do disconnect the ground from the battery. Forgot to say that but it pays off to be careful haha.

auto-elec might charge you an arm and a leg for small amounts of work but sometimes piece of mind is worth it.

I can save you the trouble of further investigation. It's the blinker mechanism. I've gone through two of them. Once the blinker stalk smokes it's finished. There must be something about the inner workings that fails and causes a short. Get a 2nd hand one and away you go. A new one would be even better.

Something that may interest you is the blinker relay under the dash. A square box with three wires. That's where your ticking comes from, quite normal. Be aware that the relay can go from time to time and may have been replaced by a universal relay. Some relays are 2 wire and others 3, one being an earth. Replace the relay with an original 3 wire relay and a new stalk, problem fixed. I did it myself but an auto electrician will put it in for you cheap.

Read the tutorial to remove the column cover and remove the screws holding the stalk. I can't remember what else there is as it hasn't needed replacing for years.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I dunno man, that VX S with 200,000 k's is still hanging out for 1.5 I reckon the R34 is the better buy, personally.
    • Dang, doesn't even include on roads.
    • Only in a market where OBD was a thing. The rest of the world was quite happy to let the US EPA only affect US cars for quite a while. The* problem with datalogs is that unless you are very familiar with what every trace should look like, on their own and as an ensemble, you can and will see weird shit that can and will lead you astray, not realising that what you are seeing is the normal consequence of various transient inputs. *Really, "a" problem, as there are of course many other problems too. Look, these cars are so bloody simple that if it is missing or stumbling, the obvious thing is to break out the old mental diagnostic list and just go do all the things that you know you should. After proving that the plugs are clean and sound, ditto the coil stalks, coils, loom connectors, etc, and then making sure that there is fuel pressure at about the right numbers (while driving!, not while sitting in the garage free blipping it), then maybe you go looking at AFM voltages, manually testing the igniter, putting a scope on the CAS, etc. Then you're into pulling the injectors for a spray pattern look-see and perhaps a clean, squirting carby cleaner around the inlet manifold looking for leaks, and all the more annoying and esoteric, but still common as muck faults that these things have. I wouldn't ever bother looking at the trims, as they are usually bullshit on these old clunkers anyway.
    • Jousting sticks! Tell 'im he's dreamin!
    • GTR owners are wankers - 2025
×
×
  • Create New...