What Have I Done?

[RB25_Zenki]

I mean splach gaurd. I was took out a few oil squirters put a skinny wire everywhere if u can hear it anywhere and still no luck.

[GTSBoy]

So let's get this straight. You're not swapping cam caps. You've only moved the splash guards?

If so, great. Drop your oil, fish through it like the boys have said. Buy yourself a supermagnet sump plug while you've got the original one in your hand and are down at SuperBarn buying new oil and a filter.

[JustinP]

I'm assuming he just swapped the splash guards... Surely!

[r32-25t]

We've already found that out

[Ben C34]

We don't know where you dropped it!

[RB25_Zenki]

So put it all back together and forget about it? Wont it cause damage?

[XKLABA]

In the 26 head there is a, let's say tunnel for arguments sake, that runs from one side to the other in the middle of the head for the oil to cross to the oil returns, check in them

[RB25_Zenki]

Its a rb25 motor

Edited December 29, 2014 by RB25_Zenki

[RB25_Zenki]

Still looking for it today and still no luck.

[GH05T]

your sure its not sitting on a cross member or something, it might not have gone into the engine but not reached the floor

[Ben C34]

Did you look under that spot near the thing?

[RB25_Zenki]

Nope looked every where. Blew the head out with compresses air still no luck. Im not 100% sure the washer went in there. So i think ill put it back together and forget about it

[XKLABA]

Just get a new one and put it back together, even if it is in the engine and manages to make its way to the sump the gause over the oil pick up will stop it getting into the oil pump

You will most likely find it one day, I once found a 13mm ring open ended in my BOV return pipe lol

[Trex]

Did you do what I said? Honestly every nut and bolt I have dropped has fallen into the splash guards and slid into a nook where a magnet would not get it. Also if you can, roll the car back and check the ground

[RB25_Zenki]

I jus hope its not near the valves cuz it will cause damage.

[GTSBoy]

  On 30/12/2014 at 2:41 AM, RB25_Zenki said:

I jus hope its not near the valves cuz it will cause damage.

If it's not visible near the cam lobes and lifters, then it is not "near the valves". The only way it could get to the valves is if it could magically teleport through the head casting.

[RB25_Zenki]

Ok its no where to be seen as the cam is out of the motor i think i will be fine.

[Ben C34]

I hope it's not near the sump plug cos then...... wait. Nothing will happen.

[RB25_Zenki]

Hahaha. Funny one

[niZmO_Man]

I accidentally dropped a coil pack bolt into the cylinder (didn't know, thought it fell down the side of the engine) on my old R32. The RB20DET spat it out without a fuss, took out the standard turbo exhaust wheel though.