Jump to content
SAU Community

Recommended Posts

should be alot clearer, as any mods on the motor will make the tune very different and someone elses tune can easily cause damage.
if your just after a simple base map, take the stock 25 base map if injectors etc are the same, and add 35% to the ve table and it should get you close to a base map for e85, yet most basemaps on ecus are pretty shocking to begin with

also is the haltec currently tuned to your car running 98?

if not and you just want it to start, you can try the r33 base map in the nissan folder on the haltec software, its the basemap from haltec, its probley shit, yet set injector size to around 700cc and leave the other settings alone and it should run, let the tuner know anything you do to the base map though.

Edited by Scott Black

so its tuned with those injectors running on 98 ron with your current setup?

if so just go into the software, and change the injector size to about 35% smaller or so and it will run alot better.
or alternativly add 30% over the entire ve table

Edited by Scott Black

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've uploaded logs / the current map to Gdrive if anyone has any ideas. https://drive.google.com/drive/folders/1FPnr22Z-EilG7tYdHSi0Qb07P2jfFLKV?usp=sharing
    • I'm running a Haltech Platinum Pro with the stock map for the RB20DET + tweaks for my build. When I started it this morning, the IAT was at 32F/0C (Outside temp was ~42F) and the AFRs went off the scale for my AEM gauge. I let it run for ~30 seconds then turned it off. I then did a smoke test, by hooking into a vacuum line directly behind the throttle body, and confirmed there was no leaks ( i let the smoke tester run for ~5 minutes / confirmed it was generating smoke before hand ). I then started the car again, after fixing a power steering leak.... and it seemed to be happy for ~30 seconds (was at ~11/12), but then seemingly shot back up to ~18 again. I then let the car run for a few minutes, thinking this was just cold start related, but the AFRs never came back down. I didn't let the car fully warm up, so maybe this makes sense, but I'm not sure what to do? The AFRs, when I last ran it, were normal, but because of personal reasons I haven't been able to break in the car. It was rebuilt last year. Engine / Mod list: Supertec pistons Spool rods Kelford 270 cams and Springs Stock crank Deatschwerks 900cc injectors Walbro 255 (Wired directly to the battery relocated in the trunk) NKG Audi R8 Coil packs + Conversion Harnesses from Wiring Specialties Holset HY35 turbo Haltech Platinum Pro ECU Haltech boost controller (wired in for high boost RB25 Neo transmission + needed bits for the speedo to work  
    • Not great at getting the camera out fast enough for cars driving. Even in traffic. S15 is in front of the kei truck.
×
×
  • Create New...