Jump to content
SAU Community

32 & 33 Gtr Parts + Man Cave Stuff! - Brisbane

nuci_gtr
 Share

Recommended Posts

nuci_gtr Enthusiast

nuci_gtr

Posted
Posted

32 gtr veilside catback $400

3.5" stainless steel, jasma approved so not too loud. Couple of minor grazes but overall good nick

32 gtr stock front pipe and cat $50

Heat shields a bit scratched up but pipe itself is fine. No holes or dents.

32 gtr door cards $40

Average condition, can probably be repaired.

33 gtr HKS hi-power catback $300

3.5" stainless steel, good nick, fairly quiet but still gives a nice note on boost.

High flow cat $150

Near new, has had a flange cut off on one end but can easily have another one welded on. 3.5".

Rb26 engine covers $100

Stock colour, suit respray. No timing cover.

Oem 33 gtr floor mats $100

Full set, could do with a good steam clean. Decent nick.

Rb26 coilpacks $60

Came as spares with my 33 gtr, car was running splitfires so never needed to use them.

R33 a-pillar trim drivers side $20

Has screwhole from gauge pod, otherwise good nick.

R33 gtr oem wing $150

In KL0 silver, couple of minor marks otherwise good nick.

R33 gtr front and rear "gtr" badges $30 each or both for $50

R33 gtr Bilstein suspension $200

Shock and spring combo, non adjustable. Sits about an inch lower than stock. Can sms pics of car to show how it sat.

Vb vending machine $500

As new condition, about a metre tall, plays vb tune when you dispense a drink. Never used. Will take any cans as well as vb stubbies. Can sms pics.

Tooheys extra dry iPod dock + esky $250

Shaped like a big extra dry stubby, about a metre high, has iPod dock on top, speakers and strobe lights in the neck and hollow in the bottom for beers. Can sms pics.

Can post smaller items, otherwise pickup Brisbane northside. Best contact is on 0419 961 fivefivesix. Any dramas or if you're after pics just let me know and I can text them through. Will add items as I find them.

Cheers, Dan.

  • Like 1
Cheaboi Rookie

Cheaboi

Posted
Posted

May be interested in the R33 gtr Bilstein suspension If there still for sale?

Also its for my 97 stagea and from what i've read it should fit i was wondering if you could confirm this? And yeah sitting to low atm scraping too much.

nuci_gtr Enthusiast

nuci_gtr

Posted
  • Author
Posted

I couldnt tell you for sure if it'll fit mate, haven't had much to do with stageas before but I'm sure it'd be pretty easy to find out. I've got a bit of interest in them already but if you pm me your mobile number I'll get you some pics and keep you posted. Cheers.

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      Dose is unaware just how much fun 145-150kw would be in a 2.5L NC MX5. It would be one of the most fun things to drive to ever grace SAU.
    • dbm7
      R33 GTS25 NA - Stalling when vehicle is at operating temp

      By dbm7 · Posted

      Same thought crossed my mind ~ depends on how one connotes 'stalling'...ie; gets a rough/stumbling idle as it get warm until it stalls... or... idles ok and simply falls-over when it gets to temp... ...you can test the whole circuit with a couple of resistors ...unplug coolant temp sensor, bridge terminals with a 2K7 resistor (ECU will do cold start), or with engine warm bridge with a 330R resistor (ECU will consider engine to be at normal operating temp)...it's a quick way to check wiring integrity/ECU response when you don't have a multimeter handy ...
    • Murray_Calavera
      Exhaust silencers/varex exhausts

      By Murray_Calavera · Posted

      They also make them with the motor mounted on the side 
    • GTSBoy
      Blue/grey smoke after idle

      By GTSBoy · Posted

      Just be warned that that turbo will not be a direct re-fit to the car. The exhaust housing is, of course, in the same place. It has to be - it's bolted to the exhaust manifold. So the dump will fit up. But the centre housing is not as long, so the comp housing will move backwards. This will affect both the turbo inlet and the outlet. There is fab work that needs to be done. Yes. it has one, it should have one. Paper gasket.
    • PotatoCake
      Exhaust silencers/varex exhausts

      By PotatoCake · Posted

      I only recently purchased the vehicle, it came with the flex setup but the current tune is e85 only, which is why im wanting to get the tune redone to enable a mixture.  First i need to get the exhaust redone tho. I was thinking of getting a varex muffler but it sems they dont fit well in the 33 (hang low because of the valve mechanism which sticks out on top) and generally dont sound good. So that leaves me with redoing the entire exhaust (more resonators and mufflers) so its not a menace when i come and go from home, and then have the aes dump valve somewhere along the line to really open it up. I was thinking of having it before the cat but after seeing how insanely loud it will be (on a vl turbo) im thinking of putting it more towards the rear of the car, after one of the resonators. 
×
×
  • Create New...