Gauge Pod Ant To Harf To Make

[MJTru]

I was looking gor a pod for my r32 gtr and could find none at a good price. Even found one for over 3 hundred dollars. Like what the hell.

I wanted it in 52mm gaige size. So I gave it a try and made one. Thought I would share my experience. Took me 3 hours. From start to finish. Ill do the 3 pod on the dash board one next. That will be a bit more challanging as they will have to me the bigger 60mm gauges.

Here is some photos

[GTR-N1]

You're very resourceful

[MJTru]

Thanks mate.

Edited March 11, 2015 by MJTru

[MJTru]

I also was looking to make some kind of switch board for a couple of stuff. This is what I came up wit. So after I did this so called switch panel. I thought up of this bar that goes from each seatbelt mounting area. It didnt come out to bad and looks the part.

[hardsteppa]

gauge pod looks good buddy. Your cross bar looks the part too, I tried making one but couldn't get my pipe bender to do a good straightline bend without kinking, yours looks like it worked just fine though.

[MJTru]

Yeah it wasnt to bad. I packed it with sand and welded it closed on the ends. Then bend it. Thats the only thing that worked. I add a bit of heat as well. Try it again mate.