Jump to content
SAU Community

Recommended Posts

these are the parts that i have left no reasonable offer denied

rear bar grey in colour bit faded $40

reinforcement behind rear bar $15

front seats out of m spec immac $300

rear seats out of m spec $90

grey carpet $40

grey hoodlining $30

fuel tank with fuel pump and sender $50

rear window $100

left hand quarter window with rubber $50

rear sub frame with hubs & control arms SOLD

gts4 or gtr front hubs control arms and struts $80

ac compressor $40

manual tail shaft $40

all plastics from center console and radio facia

brake master cyl with pipes and abs unit $100

A PILLAR TRIMS $25 EACH

LH POWER MIRROR $40

complete top end rb20det head, manifolds, turbo wiring, computer asking $400

no gearbox

no coils or ignitor

no dash or vents

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/
Share on other sites

is the boot charcoal metalic or gray as described???

Also do you have the metal lining that goes around the rear windo its a three piece metal strip thing???? PM me your mobile and i can have a chat about some stuff and prices!!!

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-931254
Share on other sites

Need 2 x o2 sensors out of GTR r32 , the ones that scew into dumps , must be working please.

these are the parts that i have left no reasonable offer denied

boot lid imac with wing off m spec gray in colour $90

rear bar grey in colour bit faded $30

rear seats out of m spec $90

both doors with all internals and glass . no door trims $200

grey carpet $40

grey hoodlining $30

fuel tank with fuel pump and sender $50

rear window $100

rear sub frame with hubs & control arms $80

gts4 or gtr front hubs control arms and struts $80

ac compressor $40

manual tail shaft $40

complete top end rb20det head, manifolds, turbo wiring, computer asking $400

no gearbox

no coils or ignitor

no dash or vents

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-931497
Share on other sites

these are the parts that i have left no reasonable offer denied

no gearbox

no coils or ignitor

no dash or vents

What about the underbody plastic bit RHF Guard - protects the BOV are from road dirt?

Odd screws/connectors from the bumper etc?

R32 GTR not sure if other cars are different

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-934827
Share on other sites

Hey man if you know if the R32 drivers side window is the same as an R33 and in good condition send pic if possible i'll take it plus its internals $130 and i'll front the shipping.

PM me. thanks

i'd say it would be different

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-939147
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I replaced the whole clutch line with the chase bays braided hose, I think it removes that loop, is it the short hose that comes immediately off the slave or is there a drawing in the manual to find what you’re referring to? It was just re-bled when I upgraded to the nismo slave, old slave worked fine but I thought that might help, didn’t change a thing. It’s like the first half of the pedal is pushing air and then when it finally actuates the master the friction zone is tiny. Makes it practically impossible to launch the car
    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
    • I would agree, unless you need something specific to the HV motor/battery side repaired or investigated, any mechanic will be able to perform normal services, but if you prefer, maybe look for a mechanic who regularly services/repairs Nissans, the VQ engines are pretty common in the Nissan lineup.  Sorry, I can't make any suggestions, I don't live in Vic.
×
×
  • Create New...