Jump to content
SAU Community

R32 Gtr Shed Clean Out, Hks, Turbosmart,oem

DannyzGTR
 Share

Recommended Posts

DannyzGTR Community Regular

DannyzGTR

Posted
Posted

Hks twin power used for couple of months with near new r32 gtr harness ready to plug and play $500

post-46271-14362452894054_thumb.jpg

Turbosmart fuel reg fpr800 $120

post-46271-1436245385361_thumb.jpg

Nismo braided brake lines for 32 gtr $200

post-46271-1436245489597_thumb.jpg

Clutch master cylinder been rebuilt using genuine nissan items $70

post-46271-14362456259871_thumb.jpg

Washer bottle $20

post-46271-14362457126292_thumb.jpg

DannyzGTR Community Regular

DannyzGTR

Posted
  • Author
Posted

Forgot to add r32 rear diff needs bearings for centre. Otherwise ok $200. post-46271-14362461956776_thumb.jpg

Also all parts located picton area, can arrange meet up in syd.

Pm me or 0422772841.

  • 2 weeks later...
  • 4 months later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      Fourth gear grind

      By joshuaho96 · Posted

      Change the transmission fluid. I would try Motorcraft XT-M5-QS if you have it in your area for a reasonable price. Also, double check your clutch is fully disengaging. If you are not pushing the clutch pedal to the floor fully for every shift now is the time to start. Make sure the clutch is fully bled. The damper line requires two distinct bleed points to be purged of air or it will not disengage the clutch properly. If either hydraulic cylinders input or output are losing hydraulic pressure in their seals/leaking you can have problems like this. If you've ruled out everything else then the most likely explanation is the synchros are worn and you need to double clutch the shift or rebuild/replace the transmission. The transfer case is discontinued FYI so you may want to rebuild it while you're in there too. If the chain stretches past spec it can do a ton of damage.
    • MBS206
      Drag radials and rims, Sydney

      By MBS206 · Posted

      You're selling the SS?! How much are you asking on it?
    • MBS206
      R34 oil and timing belt change

      By MBS206 · Posted

      My answer would be, that depends. If it's something that can be grumpy to start, runs a bit rich, and is likely an expensive engine, then yes, I would. But there's a few reasons why. Sumps aren't really sealed, there is airways to them, so it is technically open to moisture. Secondly, if as mentioned it has been started, and it's a fuelled up, I'd dump it, as chances are, fuel is in the oil. Next to that comes, how much use had said oil seen before it was parked up. IE, how much carbon, and potentially fuel/water did get in there while it was being used, and has now been allowed to sit, and slowly come together? For the most part, if it's just been something like a road car, stock engine, nothing wild, f**king send it if it's not near oil change spec.
    • MBS206
      SAUNSW - Cruise - Evening Old Pac Run - Sat 23rd November

      By MBS206 · Posted

      I forgot to say Mark, you know how if you lack sleep, we get Grumpy Mark? When I lack sleep I'm Grumpy Matt. We must be the GrumpMa's!
    • luke gtr
      SAUNSW - Cruise - Evening Old Pac Run - Sat 23rd November

      By luke gtr · Posted

      I conveniently glossed over that part.....
×
×
  • Create New...