Jump to content
SAU Community

Bnr32 Gtr Build ('murica!) Nismo Heavy

JTCC
 Share

Recommended Posts

  • 1 month later...
  • Replies 177
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

GH05T
GH05T

you must be allergic to cash  

Piggaz
Piggaz

Perfectly fine mate, almost ready to go again (didn't know the engine had a problem) ?. The Nismo donks still run cast pistons (atleast to my knowledge). What is so good about them? What exactly

Duncan
Duncan

frankly, in the current and likely future market a good condition car heavy with Nismo parts is probably a better investment than bitcoin.... also, if you are in a country with no experience or p

JTCC Community Regular

JTCC

Posted
  • Author
Posted

ok went on a job in Texas for a bit. So the car sat for a few weeks. But I got some work done.

Did the brakes.

reIfoWH.jpg

jsyfmfr.jpg

Looks a lot more clean. I think the car had original rotors and pads. The front could have been changed they had life on them....the rears were getting really close to metal lol.

Mvmc6sZ.jpg

Also got the oil cooler/relocation kit done.

zhBTrBQ.jpg

htHDRoU.jpg

WCgBP1w.jpg

l7Cb1PZ.jpg

44dZ1hc.jpg

98i0IiR.jpg

6D0b1Yw.jpg

I wish I would have tried to do an oil change first before buying this lol. It is no where near as hard to get to the stock filter as the internet makes it sound. If you have big forearms, I can see why. But if you are relatively small, try it first. It literally took 5 minutes to get off. That was because it was on pretty tight lol. Probably would have just got a sandwich plate and cooler if I knew that. But it works very well, temps definitely stay down.

JTCC Community Regular

JTCC

Posted
  • Author
Posted (edited)

Also got some more parts in. Forgot about these lol.

N1 brake air guides, these work really well with the factory undertray/ lip air guides.

gRInn8s.jpg

0sFE9XH.jpg

Also got some new turbos. Figured I'd give these a shot. GCG hi flowed -7's.

qJKVAkt.jpg

Edited by JTCC
JTCC Community Regular

JTCC

Posted
  • Author
Posted

they just go on the tension rod. I haven't put them on yet. Its just been rainy and cold here. I don't take the car out in bad weather. If you still have the factory duct work from the lip they work perfect. On standard GTR they just dump into the wheel well brake area with no further direction. These guides pick up perfectly where the ducts leave off and direct that air onto the rotor.

JTCC Community Regular

JTCC

Posted
  • Author
Posted

cool ill see if i can get them new. wouldnt mind a set

Yea I'm not sure if they are still available from Nissan. I don't think they are, but they could be. This guy just had them and never used them.

  • 2 weeks later...
JTCC Community Regular

JTCC

Posted
  • Author
Posted (edited)

had the old tensioner squeel going on. Cold weather must of really got to it. It got pretty bad, started doing it at idle also. At first I thought it could be the fan, but it never went away no matter how warm I got the engine. Sounded like it was from the front cover, so I just assumed it was the tensioner. Glad I had all the stuff sitting around. Replaced water pump, idler, tensioner, spring, cam gears and timing belt. Wish I would of had a radiator and harmonic balancer lol. Perfect time to change.

out with the old, in with the new.

poGpjw6.jpg

TvaXaAb.jpg

nmiWL1h.jpg

feamg7U.jpg

XCGFr1l.jpg

Edited by JTCC
  • Like 1
  • 4 months later...
JTCC Community Regular

JTCC

Posted
  • Author
Posted

Ok got a few parts in.

WvLs24X.jpg

Omori Factory BNR32 aluminum inlet pipes

r9hmo22.jpg

Sard racing aluminum radiator

og3dq51.jpg

G82byY0.jpg

4gDDmnX.jpg

Nismo super coppermix twin disc

ZBLAcp9.jpg

HgpqhJl.jpg

nT7iQDL.jpg

Midori hicas cancel

y6grbNR.jpg

PXnZOTy.jpg

Nismo transmission and motor mount set

skgu4iS.jpg

Nismo clutch-pivot

dAPwUnw.jpg

OEM dust boots

d2JiZst.jpg

Nismo oil air separator

Y2ziOkC.jpg

Nismo intake plenum

doRCQeV.jpg

JTCC Community Regular

JTCC

Posted
  • Author
Posted (edited)

Part 2 (picture limit)

Nismo clutch line

07CCqZg.jpg

Nismo aluminum Inter cooler pipe set

Eiifc4s.jpg

Nismo oil pump

R7GbfdX.jpg

Nismo oil pan baffle

OfDMD2J.jpg

TPymtU6.jpg

Greddy profec OLED boost controller

AIv3VHm.jpg

Fluids package

5rreTZw.jpg

OEM r32 GTR brochure and optional parts catalogue's

GMIN9Da.jpg

k1Luv8x.jpg

7Kj4DBA.jpg

9BQA8n2.jpg

cm9gNBi.jpg

Nismo 1996 vol. 7 parts book and Nismo 10th anniversary r33 parts book

NTbe9lz.jpg

KaFeQRf.jpg

LREcHjX.jpg

mGVYNgM.jpg

Edited by JTCC
  • 3 weeks later...
  • 2 weeks later...
JTCC Community Regular

JTCC

Posted
  • Author
Posted

Few more little things.

Nismo steering rack bushings

IizUYwd.jpg

OEM rain guards. Not sure if I'll use these, Just bought them for future use. I can't decide lol.

KQbFyt6.jpg

All new OEM emblems

uGt9rzH.jpg

Picked these old Recaro Crayola up. Probably put these in my s13 though. Some old school 1990's goodness.

rXDqk7v.jpg

L1J8icm.jpg

slf7Bbk.jpg

Gave the car a good wash. Took a cell phone pic. Thought it turned out pretty well for a cell phone. Nice and shiny.

zfGv8x2.jpg

  • Like 3

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      Excuse me, but 2) does apply 1) Would also apply if you consider how much is spent in the alternatives. Also there's the option of 3), buy one pre-built that you can put your family in (it's me, it's my car)   That said, I went on a ~500km drive the other day. I didn't use anything more adventurous than 3rd/4th gear at about ~3000RPM and 50% throttle and I was going as fast as anyone has any sense doing on a public road, with enough grip to the point where I didn't want to go any faster. I was obviously under the limit of the current car etc etc. MX5 with 2.5 N/A to achieve the same speed would be more fun for any road scenario. Maybe consider cams. I wouldn't boost it. The use case is just not there and it won't actually make the car more enjoyable unless you really do plan on wringing gears from 1st to 3rd (at least) at 100% WOT on a public road to 150+kmh.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Great if: 1. You had all of the money for everything else that is required  2. Lived in a country where you could actually do this and drive it legally on the road Sadly, neither applies to me As for the turbo, I am having second thoughts, mainly for engineering/registration legality reasons and insurance  Not saying I've finished doing stupid things that I probably should do to the MX5, but boost, and V8 engine swaps isn't on the cards Strange, but true 
    • Dose Pipe Sutututu
      NC MX5

      By Dose Pipe Sutututu · Posted

      I like this page, better than that silly turbo kit   https://v8roadsters.com/product-category/engine-conversions/engine-conversion-lsx/engine-conversion-lsx-nc/  
    • The Bogan
      NC MX5

      By The Bogan · Posted

      That would be my Shoei helmet
    • GabsReDeal
      R32 GTS (RB20DE) clogged cat

      By GabsReDeal · Posted

      Yes shipping here can be a pain, was about to purchase timing belt replacement kit, but it tends to get expensive due to shipping (and customs if importing from non-EU which the UK now falls under).
×
×
  • Create New...