Jump to content
SAU Community

Recommended Posts

  • 1 month later...

ok went on a job in Texas for a bit. So the car sat for a few weeks. But I got some work done.

Did the brakes.

reIfoWH.jpg

jsyfmfr.jpg

Looks a lot more clean. I think the car had original rotors and pads. The front could have been changed they had life on them....the rears were getting really close to metal lol.

Mvmc6sZ.jpg

Also got the oil cooler/relocation kit done.

zhBTrBQ.jpg

htHDRoU.jpg

WCgBP1w.jpg

l7Cb1PZ.jpg

44dZ1hc.jpg

98i0IiR.jpg

6D0b1Yw.jpg

I wish I would have tried to do an oil change first before buying this lol. It is no where near as hard to get to the stock filter as the internet makes it sound. If you have big forearms, I can see why. But if you are relatively small, try it first. It literally took 5 minutes to get off. That was because it was on pretty tight lol. Probably would have just got a sandwich plate and cooler if I knew that. But it works very well, temps definitely stay down.

Also got some more parts in. Forgot about these lol.

N1 brake air guides, these work really well with the factory undertray/ lip air guides.

gRInn8s.jpg

0sFE9XH.jpg

Also got some new turbos. Figured I'd give these a shot. GCG hi flowed -7's.

qJKVAkt.jpg

Edited by JTCC

they just go on the tension rod. I haven't put them on yet. Its just been rainy and cold here. I don't take the car out in bad weather. If you still have the factory duct work from the lip they work perfect. On standard GTR they just dump into the wheel well brake area with no further direction. These guides pick up perfectly where the ducts leave off and direct that air onto the rotor.

cool ill see if i can get them new. wouldnt mind a set

Yea I'm not sure if they are still available from Nissan. I don't think they are, but they could be. This guy just had them and never used them.

  • 2 weeks later...

had the old tensioner squeel going on. Cold weather must of really got to it. It got pretty bad, started doing it at idle also. At first I thought it could be the fan, but it never went away no matter how warm I got the engine. Sounded like it was from the front cover, so I just assumed it was the tensioner. Glad I had all the stuff sitting around. Replaced water pump, idler, tensioner, spring, cam gears and timing belt. Wish I would of had a radiator and harmonic balancer lol. Perfect time to change.

out with the old, in with the new.

poGpjw6.jpg

TvaXaAb.jpg

nmiWL1h.jpg

feamg7U.jpg

XCGFr1l.jpg

Edited by JTCC
  • Like 1
  • 4 months later...

Ok got a few parts in.

WvLs24X.jpg

Omori Factory BNR32 aluminum inlet pipes

r9hmo22.jpg

Sard racing aluminum radiator

og3dq51.jpg

G82byY0.jpg

4gDDmnX.jpg

Nismo super coppermix twin disc

ZBLAcp9.jpg

HgpqhJl.jpg

nT7iQDL.jpg

Midori hicas cancel

y6grbNR.jpg

PXnZOTy.jpg

Nismo transmission and motor mount set

skgu4iS.jpg

Nismo clutch-pivot

dAPwUnw.jpg

OEM dust boots

d2JiZst.jpg

Nismo oil air separator

Y2ziOkC.jpg

Nismo intake plenum

doRCQeV.jpg

Part 2 (picture limit)

Nismo clutch line

07CCqZg.jpg

Nismo aluminum Inter cooler pipe set

Eiifc4s.jpg

Nismo oil pump

R7GbfdX.jpg

Nismo oil pan baffle

OfDMD2J.jpg

TPymtU6.jpg

Greddy profec OLED boost controller

AIv3VHm.jpg

Fluids package

5rreTZw.jpg

OEM r32 GTR brochure and optional parts catalogue's

GMIN9Da.jpg

k1Luv8x.jpg

7Kj4DBA.jpg

9BQA8n2.jpg

cm9gNBi.jpg

Nismo 1996 vol. 7 parts book and Nismo 10th anniversary r33 parts book

NTbe9lz.jpg

KaFeQRf.jpg

LREcHjX.jpg

mGVYNgM.jpg

Edited by JTCC
  • 3 weeks later...
  • 2 weeks later...

Few more little things.

Nismo steering rack bushings

IizUYwd.jpg

OEM rain guards. Not sure if I'll use these, Just bought them for future use. I can't decide lol.

KQbFyt6.jpg

All new OEM emblems

uGt9rzH.jpg

Picked these old Recaro Crayola up. Probably put these in my s13 though. Some old school 1990's goodness.

rXDqk7v.jpg

L1J8icm.jpg

slf7Bbk.jpg

Gave the car a good wash. Took a cell phone pic. Thought it turned out pretty well for a cell phone. Nice and shiny.

zfGv8x2.jpg

  • Like 3

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ok glad you clarified on the frenchy’s options , I was worried about if my oem hoses would fit the new compressor or not if I just bought the bracket/compressor kit ,  didn’t realize they also sold a larger full conversion kit. Hmm may just go oem in that case then to make it easy only because I plan to sell this car to upgrade to a 32 GTR or 34 GTT.
    • Right, here's a video of the basic operation at least.  This is what you can expect day to day when you turn the car on and it boots from standby.  The only thing from a media point of view I haven't gotten working is for it to autoplay plexamp when it turns on from standby (it works from cold boot) but that's more of a plexamp problem as it will autoplay other music players.  Also attached is my one stray cable.  It's part of the screen's wiring adapters but there's just nowhere for it to go in my car.  I've just now done a bit of research and found a matching port on a 2010-2014 head unit with BOSE.  Mine has no BOSE so that's that case pretty much closed I think.  Plugging in the Infiniti AC panel basically did nothing for me, so that's a dead end as well.  Next port of call is to mess with this CANBUS module and see what I can find from it.  I found this resource containing the DBC files for a 2010+ G37 : https://github.com/icecube45/Dash_InfinitiG37/blob/master/InfinitiG37.dbc I'll now have something to go from when I try to extract my CANBUS data so I can see if the HVAC Mode, Fan Speed, Temperature, etc. match and also the gear shifter position.  It's a pretty big assumption that it's just mismatched CAN signals but considering all the devices in the CAN network are talking to each other (AC can be fully adjusted just with no info on screen) it might be a safe one.  I will report back WhatsApp Video 2025-02-26 at 12.49.10.mp4
    • Thanks for that Paul.  Do you think if I posted a picture you'd be able to remember where it went? 
    • Sorry Duncan, I didn't get a notification for the replies.  Thanks for responding!  It's a full Android device, but does allow you to use CarPlay/AA as well.  This is the one I bought from NaviRS on AliExpress: https://www.aliexpress.com/item/1005006368602668.html?spm=a2g0o.order_list.order_list_main.111.59aa1802JDzQ0E - the 2K 8G-256G CAM variant but it seems to have gone up by £170 since I bought it!  My purchase was £307.14.   It's not the fastest thing in the world but performs perfectly adequately.  It stays on standby unless I disconnect the battery and let it power down, then it's just a fairly standard Android bootup time from cold.  The DSP Equaliser is very nice and made the standard stereo system sound pretty decent compared to the stock screen.  Perhaps I can take a video of it when I get a sec. It *allegedly* supports the reverse camera, but I'm yet to get that working.  It has options for reverse cam (a camera unit can be bought separately) or 360 cameras (also bought separately).  To be fair it doesn't seem to detect that the shifter was put into reverse but I'm working on a theory about this as well.  At the moment I'm going without which is a bit annoying considering the car is an absolute canal barge but so far I haven't caused any damage I'll grab a picture of the wire I'm missing later today when I can get outside.  My theory, by the by, is that not only is the head unit different, but the CANBUS network has different signals for the different years.  I think this because I have a spare AC panel from a newer Infiniti G37 (as opposed to my Nissan panel) which wouldn't control anything except the volume when I had it wired up with the stock system.  I'm going to throw it back in and see if the screen will respond to it.  I've just ordered an arduino CANBUS module so I can have a look at the signals going around the car and see if I can spot anything.  I'm thinking if I can work out what it's expecting vs what it's getting I might be able to translate and relay the signal back but so far just a theory anyway. I also found this on my travels, so far the only one that specifically matches my car: https://www.aliexpress.com/item/1005002822934280.html?spm=a2g0s.imconversation.0.0.33433e5fgttovi If you look at the picture of the before, it has the card reader slot, and the picture of the head unit is exactly the same as the one pictured in my original post.  I asked if they sell the cables separately but sadly they won't.  I didn't want to just buy this one because it's a super old Android version and only dual core - likely slow as hell. 
    • As above, you did refill the coolant and burp the system before running it again didn't you?
×
×
  • Create New...