FS: M&W Pro 12 CDI

[NissTrust]

I have 1 kit which was to be used with my project, but never used.

I have the entire kit:

*All PRO CDI kits come complete with connector, connector terminals, inline fuse and wiring instructions.

I also have 4 M&W Ignitor coils, which are not included in the kit and are an additional cost, when purchasing new.

Will suit any 4 cyclinder operation, i orginally purchased it for my SR20DET, but not too sure if it can be used with a RB (6 Cyclinder) setup.

Will work with with Motec, Haltech, GEMS, EMS, Microtech, Link and Wolf systems and in many cases can be triggered by the existing factory ignition module (ie. module trigger).

Refer to www.mwignitions.com for more details or contact them direct.

This is not for the faint hearted and would be best suitable for those seeking high HP output levels. And additional support hardware to reap the full benefit.

Seeking Expressions of Interest in the Kit, **$700ono** PM only for further details

Specifications:

Part# CDI012

The PRO-12 is a dual channel version of the PRO-10. The PRO-12 is designed for direct fire (waste spark) and coil per cylinder applications. It features two separate trigger inputs and coil outputs that must be fired alternately (minimum time between channels firing = 1.0 mS).

PRO-12 MICROPROCESSOR CDI

CAUTION! Due to the high voltage used by this system (450V+), touching the primary side of the ignition coil when the engine is running may result in a painful electric shock.

PRO-12 SPECIFICATIONS

l Maximum ignition frequency = 700Hz (10500 rpm 8cyl)

l Supply voltage = 13.8 DC (negative ground only)

l Operating voltage = + 6 to +18V (restrictions apply)

l Ignition coil voltage = 450V

l Output is short circuit protected

l Reverse polarity load dump protected

l Spark energy = 100mJ

l 12V tacho output

l LED indicator power/trigger

l -40°C to maximum continuous of +100°C (case temperature)

l Dimensions W=130mm,H=50mm, L=150mm

l Weight = 800 grams

l Maximum current draw = 8A @ 700 Hz

l Dual coil output channels

Note: PRO-14 shown.

PRO-12 uses same

case and connector.

[NissTrust]

Bump, $650 ono