Jump to content
SAU Community

Recommended Posts

Hi Guys,


Up for sale is an F-con V Pro Gold with patch loom for BNR34. This came with my car when I bought it but I since had it tuned locally to suit my EFR 8374, 1000cc injectors and E85.


As you can see in the photos it comes with everything needed to plug it directly into a R34 GTR whilst still retaining the stock ecu for basic stuff. It also comes with the map sensor to suit and the loom to connect that map sensor to the ECU.


Was working fine when pulled and was only pulled out as I upgraded to an Elite 2500.


These are a great ECU for relatively little money and being one of the earlier ones there are tuners all over Australia who can tune them.


d7b5deb455.jpg

16c40d14d9.jpg

8b0ae7eeba.jpg


Price is $800 ONO.


Pickup preferred over post but will post at buyers expense. Items are located in Rouse Hill, NSW, 2155 and my number is 0403858714.


Thanks,


Brett

HKS ECUs can be tuned by Tune House as well as a a couple of others.

I have a disk manual for this too, if required - gratis.

  • Like 1
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Get a timing light on it and verify it's sparking reliably at a sane ignition timing. Use a COP extension lead to be 100% sure about timing instead of hoping that the timing loop on the back of the engine is accurate. Make sure it's actually injecting fuel. MAF is not used on the stock ECUs for initial cranking.
    • RE5R01A is the transmission. Didn't realize they had a 5 speed for the NA cars but for some reason the turbo engines stuck to 4 speeds. Looks like the solenoid block is still available from Nissan directly at a somewhat reasonable price: 31940-60X01 https://www.amayama.com/en/genuine-catalogs/epc/nissan-japan/skyline/er33/6568-rb25de/trans/317 I would move sooner on this than later. The moment the de minimis exception for Japan goes away expect to be paying 25% tariffs even for stuff like this.
    • Only RB26 are low from factory. And even then the ECU actually want high impedance, because it's essentially the same ECU as the RB20 anyway, and thus they have a f**king resistor pack!
    • Is this preventable by priming the system with external oil pressure? I've seen the speed academy folks hook up an external oil priming system to the oil pressure sensor port with an air compressor to check for oil leaks before putting an engine back in a car. Something like this: https://www.jegs.com/i/JEGS/555/23550/10002/-1?gPromoCode=SPRINGINTOSPEED_APR25_5Off&gQT=1
×
×
  • Create New...