Jump to content
SAU Community

Happy Laps - Queensland Raceway 28-11-15

Cadmoon

By Cadmoon,
in Events

 Share

Recommended Posts

Cadmoon Grand Master

Cadmoon

Posted
Posted
Event:
Happy Laps - Queensland Raceway
Description:
A chance to get out on track for a fun cruise and have some om nom noms! Bit of spirited driving is allowed but it is still an event on a race track so a few rules need to be followed (see below). Also if you have not done QR before this is your ticket in to Lakeside.
Location:
Queensland Raceway
Date:
Saturday the 28th of November.
Time:
7:00 AM Arrival
Cost:
$35 for members and guests of members riding with a member
$50 for non members
Please note that this is a per person cost, any passengers etc are required to pay as well.
Requirements:
  1. The overtaking car is responsible for completing the overtaking move safely.
  2. Overtaking is only permitted on straights, unless clearly waved passed by the car in front.
  3. Overtaking move must be completed well before the end of the straight, and the car being overtaken must be given plenty of room.
  4. Cars should not be more than 2 abreast at any point on the track.
  5. Be aware of cars around you, in front and behind (and beside when being overtaken).
  6. Do not assume that the car in front of you knows you are there.
QR RULES
  1. There is to be no racing.
  2. Any car that goes off the track will be pulled off.
  3. There is not to be more than 1 sec of tyre smoke.
  4. There are to be no helmets.
  5. Vehicles must have current registration and number plates are not to be obscured in anyway.
  6. No roll-cages, even if mod plated.
  7. Drivers must hold a valid driver's licence

Payment Details:

Name: Skylines Australia Queensland Club

Bank: Westpac

BSB: 034 063

ACC: 354012

PAYMENT REFERENCE: Username&HappyLaps

Attendees:
  1. Cadmoon +1
  • 1 month later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • weikleenget
      R32 GTR clutch master cylinder adapters

      By weikleenget · Posted

      Hi again all, I’ve tried doing some searching on the topic but couldn’t find the answer I’m looking for.   I deleted my clutch booster because it had an air leak and was squealing like a hog, and now my clutch has very poor pedal feel and the friction zone is way too small, so I believe I need a bigger diameter clutch master cylinder to compensate for not using the booster. I found a Wilwood option that’s 3/4” for a good price and will fit my 3AN clutch line, but all the firewall adapters I see online such as RB factory or Chase Bays are listed as RWD only (GTST/GTS). Link below. https://rbfactory.shop/products/nissan-to-wilwood-girling-clutch-master-cylinder-adapter My question is if these adapters will also fit a GTR, and if anyone has experience using a 3/4” CMC without the booster, my clutch is a Nismo coppermix twin plate.   Thanks, always appreciate the advice!
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      Catching up on a post, I've replaced the external shark fin with a small 4g antenna (no further drilling, just a 1mm embiggening of the existing hole, and run that to where the dual battery models have the battery in the left rear guard.  No idea what the factory antenna did, but removing it had no impact on anything I use, according to the US manual the GPS antenna is in the dash and it still works fine Also ended up stealing battery power from one of the amps and ACC power from a unit nearby to add an ACC relay to power it. The mounted the booster, wifi, power socket and antenna splitter in the rear left guard out of the way, all out of site with the boot trims in
    • GTSBoy
      Skyline R34 Suspension Drama

      By GTSBoy · Posted

      What drama? The only drama you're going to have is the near constant work to maintain all those sphericals. I only have sphericals in my front caster rods and front upper CAs (because both of these are near compulsory in an R32). I have had the front arms out of my car 34 times already this month, and if the new replacements arrive today, I will have them out and apart again tomorrow. Chasing clicking and clunking that comes from sphericals being a.....poor choice for a road car. Moisture and dirt are not their friends. I have been contemplating a change to my rear subframe that would require me to use sphericals in my lower CAs. And.....I don't want to have them that close to the road.
    • Kinkstaah
      Skyline R34 Suspension Drama

      By Kinkstaah · Posted

      Did you need anything else you've already done? If you had it before... and liked the changes after, then supposedly it'd be more of the same. The idea about most suspension arms is to tune geometry that the OEM arms max out at/can't handle because they weren't designed to have the car setup in such a way that 'looks good'.
    • drifter17a
      Skyline R34 Suspension Drama

      By drifter17a · Posted

      I have replaced everything on my r34 including suspension to Miester R, all rear subframe bushes to poly, all arms to metal adjustable and same in front.   only thing I haven't touched is the front lower control arm. Should I? what improvement can i expect ? I mean the one on the link below?   Car drives perfectly, it is just me thinking everything is either puly bush or hard bearing type so should also do lower control arm front but do I really need it ? https://www.japspeed.co.uk/product/suspension/adjustable-arms/nissan-200sx-s13-s14-s15-skyline-r32-r33-r34-adjustable-suspension-front-lower-control-arms/?gad_source=1&gclid=Cj0KCQiAo5u6BhDJARIsAAVoDWs5V_PauQPf0kx3zFCaA4tOC9Q7JSIsfJWma_jAPN2f1sJA686djOwaAidgEALw_wcB
×
×
  • Create New...