Jump to content
SAU Community

Recommended Posts

Hey guys, I did a bit of searching around but couldn't find specific answers for this;

What would be a more suitable oil in a stockish R34 GTT - Royal Purple HPS or their new XPR oil?

It seems the XPR is a on up from the HPS, specifically for performance racing, does that mean it would not be suitable for a daily jap turbo?

This is what their website has to say; (useless)

http://www.royalpurpleconsumer.com/right-synthetic-oil/

Thanks :)

Link to comment
https://www.sau.com.au/forums/topic/462838-royal-purple-hps-or-xpr/
Share on other sites

I use hps 10w 40 In my turbo territory as its supposed to be the more daily driven oil choice with more detergents than the xpr which has higher zinc and less detergents but has a boiling point of up to 400degc from what I read from there data sheet. Both are at least a group 4 which is the more important factor here I reckon.

The ultra high performance oils (XPR, Motul 300V competion, Redline Race series) are very good in terms of dealing with high heat, high strain conditions

however this is only 1 of a 3 part equation - the are;

1. Heat tolerance - pure performance

2. Cleaners, detergents and additives - ongoing engine maintenance / protection for cold starts

3. Oil longevity (suitability for longer time/km intervals)

You have to remember racing cars differ to street cars in the fact that they;

- oil is constantly changed out every event - meaning it does not require a complex detergent/additive package to clean the bearings etc.

- constant changing also means the oil does not need to last very long time/kms wise

So the reality is the best oil for track is not the best oil for street

What you will need to settle for is an oil with a moderate heat/sheer tolerance, but also have a detergent package + resistance to acidity to last and clean over a 5000, 10,000 or 15,000km interval

If you still wanted to spend upwards of $80 my picks would be Redline (normal series) 10W40, Motul 8100 Xcess or Amsoil 10w40 (Motul and Redline are available at most Autobarns)

Good options under $50 are Penrite HPR10 (when on sale), Gulf Western Syn-X 3000, Castrol Edge 0/10w40, Valvoline SynPower 5w40

An great medium is the Gulf Western Syn X 6000 if you can find them in Autobarn, or buy direct - they are very close to your full Group V(5) ester based oils like Amsoil, Redline, Motul 300V, but at a fraction of the cost, around $50-60 i believe

Hope that helps, everyone wants the best for their ride, just need to adjust your understanding of oils to make a more informed decision

  • Like 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I definitely do recommend having a fab/grinding/dirty shed or area to keep all that grinding dust out of your main shed.  But you're right, it doesn't matter how much room you have you still end up filling it! I might even do a short video which will make it easier to fully take in the horrors of what I've created...
    • Actually No, I’m not as intuitive as u
    • It only looks tidy, as most of the stuff that was on the whole back wall, is now in the trailer to go to the tip, or has been shoved in my 2.2x2.4m "Spare parts room", and now I can't get to anything in there Ha ha ha I could definitely do with a bit more space, but I'd just end up with your problems I'm going to enclose the car port beside the garage, and move a lot of stuff into it I think. OR... It will be setup as a fabrication area, and the main garage will have parts storage in it. I'm not sure yet... Need some pictures of that big shed you've got with the bikes and Skyline in
    • No. I think it's gone. 😭 I think you can get body coloured ones on eBay so I think I'll get one of those... Or just hang a red ribbon from the hole and whack a TOW sticker next to it.
×
×
  • Create New...