Mine's Triple Plate Cam Cover Baffles

[Sammywhtkntbnr34]

I just bought a pair of Mine's baffles from japan

Its ment to be direct replacement from what i know. I received 4 sponges and 2 plates

Online there is a guide how to install em mine's baffles but no sponge is mentioned and they have also mentioned the stock separator to be replaced when installing the mine's baffles?

unless im Reading it wrong or they have missed Something.

Has anyone had trouble install em?

Do i have to do some altering?? So it fits

Also when you place the sponges in the cam cover even without the stock separator the plate doesn't sit where its ment to..

Dont mentioned the stupid installation guide on the net its shit.

[its cardo 1987]

Since this is an out dated post im sure you would have found the answer.. but i just did this myself over the weekend and thought i might detail what i did as i was confused in the same way.

I took out the stock baffling and the mesh separator, then put the sponges in laying flat (not on their sides, you have to compress the sponges to fit but once they are flat and inside the cam cover everything fits as it should) in the cam cover as far back to the breather holes as i could get it. Then put a thin layer of gasket maker around the edges where the factory sealant was, pushed down the mines baffles and screwed them back in place then ran the sealant around the edges once more. I've still got them off the car as im sending them to paint but i hope this helps anyone else who was stuck.