Jump to content
SAU Community

Recommended Posts

  • 8 months later...

We took the car to the track. The car got stuck in safety boost some how. Also ended up killing the front diff. Customer does not want to go back to the track yet and risk hurting the car again.

 

Edited by Jc052685

"there will never be a trap speed shared."

So I win $50?

Don't stress though, as this is the reverse situation where your number is actually smaller and it's a good thing. $50AUD is like $3.50 USD these days ;)

 

  • 3 years later...
18 hours ago, Torque Curve said:

Has there been any good modern setups with twins lately??

 

So far the only "modern" twins setup that I've seen which has generated a result which gets one thinking is the PMC/Integrated Motorsport R34 GT-R which makes >1100hp @ crank on G25 660s.  It's laggy as hell, but has a wide (like 6000-10000rpm?) power delivery so there is a bit of a swings and roundabouts thing going on there - you would NOT use that for what most are looking for with twins, not least because it's not stock location but instead some wild fabrication involved.  I don't expect there to be any major development with stock location twins as turbo tech isn't really the primary hold up, it's mainly packaging limitations imho... which is a lot of why I'm so pro-single on an RB.


BTW, this thread is hilarious to look back over.

  • Haha 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Yeh... literally every time i jump on a forum, see an instagram post or see an engine bay at a car show, i get an idea and add it to my 'to do' list. So what started off as, hey can u just make a couple of intake hard pipes because my dumbass bought the wrong apexi kit, blew out into a 2 week job including braided brake lines & custom bash kit for the front lip haha.  Getting Luke from A4E engineering to make a full custom exhaust with a controllable aes dump valve so i can actually switch between quiet and loud, because right now its just loud all day every day. Then after that go and get the tune redone flex e85 & 98 as i get bugger all milage from e85, makes going for longer drivers difficult
    • Car looks clean as. You ended up getting quite a bit done 😂  So what's the plan for the exhaust? 
    • The only Neo rods that were any different to any other RB25 rods were the DET ones, and they were the same as RB26. Here is a Neo DET rod. O5U part number visible. Here is a post in a thread here on SAU with evidence from someone who has done this before. There are photos in the thread of normal RB25 rods.  
    • Sure, but why assume that will be the case forever? And why assume you'll be able to do an oil change to swap back to a stock drain bolt before that happens? And does it even matter when I change the oil at fairly short intervals? Life can be funny sometimes and unexpected things can happen. Like breaking a collarbone so you can't do any work on your car for a few months but the oil change is due so you have to take it to somewhere and hope they don't do something stupid like stacking the new drain plug washer on top of the old one.
    • Do u know how to identify the rods are rb25 or neo ones? Can u look into the pics and tell me is they de or de neo ones. Its confusing becoz my motor has de neo head but block is 25de 75t, so really confusing me about rods, crank.
×
×
  • Create New...