Jump to content
SAU Community

Recommended Posts

Hey Folks, looking to get a batch of stickers made with the SAUWA logo. looking for numbers before i proceed so i dont get stuck with too many.

Can either get the logo printed on a clear sheet as previously done or vinyl lettering individually cutout with a sheet over the top holding it together for ease of fitment.

The vinyl option is only a few cents more and the owner said it should last about 7 years before fading whereas the print on clear sticker might fade after 2 years. i'm keen to get the vinyl from his recommendation.

I've priced it up for a quantity of 50 assuming everyone will want 2. they are 200mm wide by 100mm tall.

Pricing would be 2 x stickers and postage for $10. If i can get 10 pairs confirmed im happy to proceed but if i cant secure that many then i will only do a very small order for a couple of us however the price will likely increase.

so who is keen?

Link to comment
https://www.sau.com.au/forums/topic/463559-sauwa-stickers/
Share on other sites

^^

Aww just about finished writing and my stupid phone deleted what I was writing when your message came through, all good!

Hey guys, does anyone mind if I increase the size a little?

Originally I said 200 x 100 but there is a little bit of fat left in the $10 I quoted. I'd rather everyone get the biggest sticker possible for the money your paying. Not sure how much bigger, maybe 250 x 120. Just thought I'd check incase anyone had a small side window in mind...

I'll contact the supplier tomorrow and see what they can do for me and hopefully put the order in.

Any problems let me know

Trev

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/463559-sauwa-stickers/#findComment-7698912
Share on other sites

All good - do it!

^^

Aww just about finished writing and my stupid phone deleted what I was writing when your message came through, all good!

Hey guys, does anyone mind if I increase the size a little?
Originally I said 200 x 100 but there is a little bit of fat left in the $10 I quoted. I'd rather everyone get the biggest sticker possible for the money your paying. Not sure how much bigger, maybe 250 x 120. Just thought I'd check incase anyone had a small side window in mind...

I'll contact the supplier tomorrow and see what they can do for me and hopefully put the order in.

Any problems let me know

Trev

Link to comment
https://www.sau.com.au/forums/topic/463559-sauwa-stickers/#findComment-7698922
Share on other sites

Dan the Man is busy with some stuff at the moment - don't wait for him he has some important shit on his plate.

Just do what you need to mate,

Im ok with that or if you wana do a 50/50 in the sizes im ok with that too.

  • Like 2
Link to comment
https://www.sau.com.au/forums/topic/463559-sauwa-stickers/#findComment-7698936
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • All I can say Duncan is good luck and I hope that Neil did not run any E85 in Cheryl. I have recently experienced the full spectrum of fuel tank issues in my R33's that had been caused by E85 and contaminated fuel. When you take the cover off the top of the tank and have a look inside you will get an understanding of how easy it will be. Best case situation is clean fuel with minimal contamination. My GTR was like this and it was a very simple operation to just grab the fuel pump carrier bracket and slide it up and out of the tank. My three GTS_T's had different levels of fuel contamination that was probably caused by E85 in the fuel.  In the worst case all of the metal components in the tank had rusted to the point where there were pieces of rusted metal swirling around in the tank. This required the removal of the exhaust, the tailshaft, the complete rear cradle and the fuel tank. The components in the tank were that rusted that it took days to get the fuel pump carrier and the mounting brackets out of the tank. When the tank was finally cleaned, everything inside the tank had to be replaced. With the tank all back together I could then reinstall it in the car along with everything else that had to come out. Good luck and I hope that you find a clean tank.    
    • It is a two door. It is black and also still has the OEM wheels and stereo. Exact model would be KR_R32RGFEL_SS According to GTR-Registry.com is a 2 Door Coupe; RB20DE; 2WD no HICAS; MT.F5; (11L) Projector Headlamps and Fog Lights; (12_) Electronic Active Full Auto Air Con (Climate Control); (13-14SS) V Selection -- Which seems to be accurate description of my variant. Will try to upload a few pictures soon. The OEM wheels look like the below image. Image is taken from the goo-net-exchange website.  
    • Time: Saturday 18th January - 9am -10:30am Where:  Cafe By Lamanna 10 English St, Essendon Fields VIC 3041  - https://g.co/kgs/mhVKvAB Registration: So we can give the cafe a heads up on rough booking numbers please rsvp below Registration Link: https://forms.gle/wPtfj9Gp8bvCiouo8
    • Welcome Gabriel. At least your car has a glorious RB and not the shitty CA18. As MBS206 mentioned all the good bits can be added later. Two doors or four?
    • And half of them have been converted to turbos.
×
×
  • Create New...