Mines Oem Din Boost Gauge

[rbpwrd240]

Anyone running one of these? They go up to about 22PSI and don't have a negative pressure side. Also it says MINES on the boost gauge. If anyone is running one I would like to ask if you need to have the Mines Boost sensor or will it work on the factory Boost sensor? Im trying to figure out how it registered the higher boost levels on the gauge.

Thanks,

Alex R.

[niZmO_Man]

I have the R32 GT-R one. Is that what you have? Straight swap into standard wiring/sensor.

[rbpwrd240]

Good Deal. I just got this one for my S14.

http://page9.auctions.yahoo.co.jp/jp/auction/k210432811

I'm guessing it uses the OEM S14 Kouki sensor which I have, if by chance its actually an R32/R33 gauge that was swapt into the S14 DIN housing to read higher boost then I should just need the OEM R33/R32 boost sensor. Hopefully....

If it is an R32/R33 gauge will an RB25 sensor work or does it need to be a rb26 sensor?

Thanks,

Alex R.

[niZmO_Man]

Not sure if the signal sent to the gauge is the same between the Silvia and Skyline.

Looks like you got a good buy. I was after the black faced ones, can't find any sigh.

[rbpwrd240]

They are different signals but I figured I just need to match the boost sensor with the gauge. I haven't seen these for S14 so I wonder if the gauge is actually from a skyline DIN and the previous owner just used a skyline boost sensor. ??? Guess I will have to just wait and see.