R33 gtst Silicone turbo hoses

[vxsr33]

Was looking at replacing the stock rubber joiner hoses on my r33s intake piping, to silicon ones.

I need:

-2× 60mm 90° bends

-1× 60mm -> 65mm hose approx 100mm in length

-1× 70mm hose 70mm in length

- 1× 60mm hose 110mm in length.

I have tried to look for info and where to get silicon joiners of these sizes from, but i cant really find anything

just after some suggestions as to where i can get these silicon hoses and what brands to go for (is sca or autobarn brand good?). Also will 63mm (2.5 inch) fit over 60mm and 65mm tubing without any issues?

I appreciate any help, and im located in melbourne west suburbs.

[Jordy32]

Stock is fine. Are they leaking?

cant find silicone joiners? Have you looked? If you're replacing them use good quality clamps too..

 

ebay and/or justjap for starters will have what you're looking for in all sorts of colours.

[vxsr33]

I dont think they are leaking. Just looking really worn and for preventative maintainance for an upcoming tune.
I found some aeroflow hoses on ebay that look good.
Does anyone know if 63mm or 57mm hoses will fit 60mm piping properly. Or do you need 60mm hoses specifically?

[jmknights93]

http://justjap.com/catalogsearch/result/?q=silicone

Have fun going over the list... Free shipping.

[Fry_33]

I purchased quite a few of the hoses I needed from RP Wallis (Spareco), http://www.spareco.com.au.  They are over in Oakleigh so unfortunately not local to you.

The actual website doesn't have the full info on the lengths of reducers etc but the below link has details on their  black silicone hose range.

http://spareco.com.au/documents/pdf/Performance Hose 22-02-2015.xls new.pdf

When looking to fit smaller hose over a larger pipe don't forget to check the barb diameter of the pipe.  You first need to get the hose to go over that.

Good luck