Jump to content
SAU Community

Turbosmart dealers

Trex

By Trex,
in General Automotive Discussion

 Share

Recommended Posts

Trex Grand Master

Trex

Posted
  • Author
Posted
I'm just pointing out that you can buy straight from Turbosmart.



Thanks, bob. But they're about $100+ more expensive than anywhere else.

I was mainly putting my feelers out for a forum member or trader who can get good deals on turbosmart products for club members etc :)
  • Like 1
Trex Grand Master

Trex

Posted
  • Author
Posted
Street to track. He was the cheapest for a 50mm I'm about to order



I will send them an email. Their website is a bit lacking and haven't heard much about them before.

Golebys has the 45 for $420 and vpw are $390. I'm more inclined to go with golebys as he is very well known in qld and a lot of SAU members.
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • silviaz
      Rb25det Belts Change

      By silviaz · Posted

      Gosh these Rb pulleys/alternator or whatever is causing the problem is absolute rubbish lol. Haven't even done that many km on it.
    • 25RBGT
      Got this r31 silhouette flood car to rebuild.

      By 25RBGT · Posted

      Yeah man, will only progress further hopefully. The bonnet is coming off to get sprayed very soon
    • joshuaho96
      Rb25det Belts Change

      By joshuaho96 · Posted

      Once the belt slips it can very easily cause a cascade that encourages more belt slip. Check the pulleys carefully and see if the grooves have cupped. If it has it's time to replace the pulleys. If the rubber has glazed you also need to replace it. Shouldn't be shiny. From the factory there's a lot of exposed fibers(?) on a v-belt that will go away as it's broken in but some should still remain visible without sticking out significantly like a new belt. I went through this on my dad's Camry recently. It would keep slipping even after setting the tension higher, only solution was a new belt.
    • GTSBoy
      Rb25det Belts Change

      By GTSBoy · Posted

      Belt polished and/or pulley(s) glazed. Rub pulleys with sandpaper, replace belt.
    • Murray_Calavera
      Quick Lifts? Anybody got one?

      By Murray_Calavera · Posted

      I've also got a quick jack. I would never get under my car again without using it.  While it might be quicker to use a jack and stands, it is such a quality of life improvement that I wouldn't have it any other way now.  How much slower the quick jack is to setup will be based on your circumstances. Can you leave the jack rails on each side of the garage? Can you leave the hydraulic lines attached? etc.  If you can drive the car into the garage and simply push the jacking rail thingos under the car into place, it is super quick to setup and use. But if you have to pull the pump unit out of storage, attach the hydraulic lines, wheel out the lifting rail thingos.... yeah takes a bit of time. Having said that, I would still prefer that to using a jack and stands lol. 
×
×
  • Create New...