Jump to content
SAU Community

[SOLD] R34 GTR Wheels with Federal SS595 255/35/18s

andyseven
 Share

Recommended Posts

andyseven Enthusiast

andyseven

Posted
Posted

R34 GTR Wheels with Federal SS595 255/35/18s

For Sale $1600 ONO

R34 GTR Wheels 18x9+30 with Federal SS595 255/35/18s

All tyres have heaps of tread left cheek the photo with the key in it - all still have spikes in the edges these haven't been used much at all.

All rims have centre caps

All have minor tyre fitting marks - nothing too bad - just being honest.

One has some minor rash and a scratch - see photo - its not too bad.

One has a very small chip its about 3mm MAX - see photo.

Other 2 just have fitting marks.

These are good used wheels with great near new tyres - just so we are clear they are NOT mint - if your looking for MINT wheels for your show car these are not for you, if your looking for a decent set of R34 GTR wheels for your street or track car BINGO!

Sydney Pick Up ONLY - I'll meet you pretty much anywhere East of Penrith, I'm in Kings Cross but have a Station Wagon and am more than happy to drive and meet you somewhere reasonable.

 

Check the photos - All taken 10/11/16 - Off my car (R32GTR) and ready for yours.

$1600 ONO

Andy

0402 350 827

IMG_5467.JPG

IMG_5468.JPG

IMG_5469.JPG

IMG_5470.JPG

IMG_5471.JPG

IMG_5472.JPG

IMG_5473.JPG

IMG_5475.JPG

IMG_5476.JPG

IMG_5477.JPG

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kyer32
      R32 gtst speedo out by 10kph

      By Kyer32 · Posted

      Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • Kyer32
      R32 gtst speedo out by 10kph

      By Kyer32 · Posted

      so I need a new speedo cable 
    • tsuokun
      R34 GTT RB rough idle problem with weird RPM gauge fluctuations

      By tsuokun · Posted

      Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • niZmO_Man
      R32 gtst speedo out by 10kph

      By niZmO_Man · Posted

      Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • niZmO_Man
      Rv37 400r questions

      By niZmO_Man · Posted

      +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...