Jump to content
SAU Community

Recommended Posts

3 minutes ago, ActionDan said:

Looking good.

His wiring guy probably needs to learn how to use a ruler or go to Specsavers ??

Never ending saga with this car. Decided to get a decent coil kit, and surprise doesn't fit like a decent kit lol 

1 hour ago, GTofuS-T said:

Looking at the first pic again, what was the actual issue? it all looks like it's plugged in and nice and neat compared to the latest pic...

the last coil pack has been turned around so it clears the covers, however you can see the last connector is too short hence the loom is compressed and sits stupid.

So did some last minute road tuning during the week and poured in E85 (because no idea how much timing the motor can take safely so used knock suppression fuel lol) and then took the shit box to a skid pad. 

LOL... Was interesting to say, things to note:

  • a car setup for the track setup doesn't work on a skid pan very well :D 
  • a big laggy turbo isn't great on a skid pan, comes on you spin out, clutch kick and you bog
  • can't slide around at 4k rpm in 2nd, it bogs, rev it harder and spins out once the turbo comes on (lag life)
  • semi slick tires on the rear not a great idea either (borrowed some drift tyres afterwards)

I'll upload some in car footage soon once. I pull I pull it down from my VIRB.

Even the seasoned drifters had a go and couldn't slide it properly in 2nd, mainly slid around in 1st lolol

IMG_20181122_203912.thumb.jpg.b04d51fddda275c3b56aa0edbe1782a5.jpg

  • Like 1
2 minutes ago, BakemonoRicer said:

Time for an EFR mate

More like time for a smaller sensible sized turbo if I want to play in this sport, but my heart lies in circuit racing, powercruise and roll racing.

Anyhow, not bad for a shake down. A few things I've noticed after yesterday:

  • I didn't seal the sump properly, there's a weep at the front (using a RWD sump on a AWD motor, doesn't seal well)
  • turbo is too big for drifting
  • should have bought a M235i BMW or a 335i BMW lol
  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks   does painting on aluminium work or stop them from corroding?
    • 'Sgot nothing to do with them being Japanese. The climate in the north of Japan has similarities to the UK - the cars are made in the knowledge that they have snow and salt, and they rot there. Cars made in the US rot like buggery in the US. British cars have always rotted regardless of the weather. They will rot indoors in a climate controlled bubble! The brackets are not unsafe yet, but they will get that way. They may well corrode where the bolt threads are in contact and the bolts could just jump out without warning.
    • So unsafe would you say now?   little bit of has come off, guess road salt is a nightmare for Japanese car. Mx5 here have a well known issue or rotting 
    • Dissimilar metal corrosion. Aluminium is less noble than steel/iron, and will corrode preferentially when in contact with it and a conductive solution (ie, wet road salt). Tends to suggest that those brackets should be made in steel for a shitty climate like the UK.
    • Here is picture of the rear brackets again seeming to have eating itself or corrode or whatever. Can’t describe it , hope someone could explain this    
×
×
  • Create New...