Jump to content
SAU Community

Recommended Posts

Hi,

I need someone in QLD who can tune this ECU, Gavin Woods can't, Sub-Zero can't, all the HKS dealers can't.... I rang up BD4's in Sydney which is a HKS ProDealer and they reckon they are the only ones in Australia who can tune this ECU. If anyone knows of workshops in QLD who can do it let it be know :)

Otherwise I will be going on a little roadtrip ;)

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/
Share on other sites

  • Replies 74
  • Created
  • Last Reply

Top Posters In This Topic

be careful with the HKS Fcon V ecu's. Not many around australia know how to tune them because most the time the language is in Japanese and u need HKS accreditation to recieve access to the software. Only time i've heard of ANYONE in australia tune one was when Susumu Koyama from Jun Auto in japan went over to perth to tune a few cars (inclusive of a sexy looking grey R34 GTR)

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-950906
Share on other sites

I just spoke to Jim @ Croydon Racing Developments (CRD) and he is trying to source the HKS F-Con S/V laptop software from HKS at a cost of $4000 so he can tune this excellent ECU...

Just remember that actual costs always run nearly double what he quotes you. Keep that in mind and you'll be fine.

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-950907
Share on other sites

;) um, you could pay twice the money to get something like that tuned..

or throw it out and go for one of the common ones that can be tuned by anybody. Its a waste in a way, but unless you can find a good tuner for it, what is the point?

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951015
Share on other sites

Ok the deal with HKS computers as far as i know is:

FconV

Does fuel only. Now the bad thing with this piggyback ecu is that the standard ecu will still retard timing and add/remove fuel 7.5% either way of the tune put simply. I like to think of it as HKS's answer to the SAFC. Who would pay someone big money to tune an FconV or FconS when you could get an safc done for 200.

FconV Pro

Does fuel and timing and shitloads of other stuff, comparable to a motec, but still not as comprehensive. With thi ecu you have to buy an air temp sensor and a MAP sensor to make it work, an additional $1000 ontop of the ECU. Also it is still a piggyback, leaving the standard ecu to do aircon and demister etc. the fuel/timing is eliminated with a special harness which isnt cheap too. Tuning was very expensive last time i got a quote, it put me off getting one of these ECU's. Imagine forking out truckloads of money everytime you do a mod just to tune your car to it.

-rb25

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951147
Share on other sites

Serious question, and not a go at you or anything....

If its a step below the PFC, and you have to drive from the sunny coast to sydney for tuning ... Why use it instead of the PFC?

If there are some magical features ross hasnt pointed out yet (although I guess MAP is an advantage over MAF) I'd be interested in hearing them. Always open to new ideas and suggestions for ECUs :rolleyes:

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951859
Share on other sites

rb25 the HKS FCON V is worlds apart from the Apex SAFC, maybe one step behind the Power FC, for reference I have the Pro Version and BD4's do have the Pro Software.

for sure, it is more comprehensive than an safc, but at the end of the day, it does fuel maps, not timing, and imho thats ordinary anyway. powerfc is the go.

-rb25

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951880
Share on other sites

In Perth a guy is flown in over from Japan and all cars a done in one hit, it isnt just about having the gear and software it is all about knowing how to tune the software.

One shop here blew two motors and they hadent started to look into tuning, ripped it out and put in a Micro Tech (RX7).

Power FC is the way or something that a good local tuning shop can work on.

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951891
Share on other sites

Serious question, and not a go at you or anything....

 

If its a step below the PFC, and you have to drive from the sunny coast to sydney for tuning ... Why use it instead of the PFC?  

Because it is the pro version, which is proven a better ecu over the apex power fc.

The pro version is pretty much a MoTeC but uses a piggyback system.

And yes RB25 I have the harnesses and what not.

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951947
Share on other sites

i believe what Krawler is trying to say is ---> Why is it so much better than the Power FC? therefore making the drive to sydney worth it. Why couldnt u sell it buy a power FC and have it tuned here and save yaself alot of trouble

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-951985
Share on other sites

you can now get a newer PFC's will do MAP as well..

i think everybody is pretty much along the same lines though.. $1200 on a PFC, or lots of ****ing around and maybe headaches with the HKS. The HKS may in fact be a better ECU, and I have seen quite a few hypo GTR's with them in japan - and some 9second GTR have had them.. but if you can't get it tuned, or tuned properly more importantly its all a little irrelevent

Link to comment
https://www.sau.com.au/forums/topic/46850-tuning-hks-fcon-v/#findComment-952358
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I remember the days when E85 was priced in according to the $ per km outcome. Sure E85 was about 35% cheaper, but you also lost about 35% range... now it's fked..
    • They do. The pale yellow translucent ones from Japan were .... I dunno. Useless? Whiteline and SuperPro are probably fairly similar. There's bound to be a range of different hardnesses amongst the dozens of options on the market. The simple fact is that the pineapples don't get up inside the bush at all. They just sort of exist in the space between the washer/bracket and the subframe's bush outer tube, and...exert a bit of force between them? Or something like that. I'm sure that with enough provocation, they will simply allow one to move wrt the other.
    • I'm not sure they came in different hardnesses? Going from memory only - I had set them up in the balanced setup. I also have poly bushes, so I have both poly bushes and pineapples. This is what my memory tells me at least. I'll have to take a look under there to be sure. The tramp was so bad that I managed to eject/kill a diff bushing, so those I know are stock. The tramp is bad enough that you are 200% sure you are doing severe damage to the car. It's not just chirping or vibration, it feels like you're hitting a speed hump/kerb 10 times a second. The issue has persisted between subframes! (I went from Hicas to non hicas subframe and replaced every bush a few years ago now) so I'm entirely lost. Every arm is factory.
    • Can recommend the Frenchys kit, been using it 2 years now with no issue, very happy with it.  Only thing for me was upgrading the thermo fan but I am super fussy on cooling.   Also interested in electric AC, partly for boot mount to have a clean bay and partly would love the idea of cooling off the car before i get in. The battery setup to do that might be tricky / expensive though.  Found this an interesting watch.    
    • I put Whiteline pineapples in my old 33, they came in a 6 pack of them, got rid of the axle tramp altogether, cheap, quick and easy install,  they were pretty solid units though...???high durometer???? and NVH was increased a fair bit How hard are the ones you installed?
×
×
  • Create New...