Jump to content
SAU Community

Trust Titanium Cat Back Exhaust R32 GT-R

ph1
 Share

Recommended Posts

ph1 Rising Star

ph1

Posted
Posted (edited)

Trust Titanium Cat Back Exhaust R32 GT-R

Selling a Trust Titanium cat back exhaust to suit an R32 GT-R (maybe GTS-t?)

Light weight and high quality exhaust, in excellent used condition, no dents, obvious scratches, etc.

Does have a few water marks so could do with a polish of some sort.

See attached photos. Appears to be 3" (76.5mm) internal diameter, 115mm tip, comes with original documents & Jasma certificate.

Located in Brisbane, looking for $1400 ONO, can ship at buyers cost.

2017-04-07 13.41.31.jpg

2017-04-07 13.41.41.jpg

2017-04-07 13.41.59.jpg

2017-04-07 13.42.45.jpg

2017-04-07 13.42.54.jpg

2017-04-07 13.43.01.jpg

2017-04-07 13.43.12.jpg

Edited by ph1
added size info
  • Like 1
ph1 Rising Star

ph1

Posted
  • Author
Posted (edited)

Weight is 8.6kg, 4.8kg for mid-section and 3.8kg for rear section.

Unsure how much use it has had, came off a car I just imported with under 25,000 klms, but not sure when it was fitted.

Can freight to eastern states for $50, will need to check costs to other areas.

Edited by ph1
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • sunsetR33
      ugently need expert / experienced opinion

      By sunsetR33 · Posted

      Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • Butters
      UniClutch

      By Butters · Posted

      hrmmm , not mine , easter plans to pull engine not happening     
    • DRoc81
      R33 GTS25 NA - Stalling when vehicle is at operating temp

      By DRoc81 · Posted

      I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Milkmun
      Magnetic Drain Plug Snapped in Half

      By Milkmun · Posted

      At least it was the ex.
    • Murray_Calavera
      Troubleshooting - motor wont turn over

      By Murray_Calavera · Posted

      Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...