Jump to content
SAU Community

Recommended Posts

hey guys i expect to be pushing around 190rwkw when i install and tune the mods i just bought for my car (boost controller, fmic) or am in the process of buying (apexi safc) already got the full exhaust and air filter. Now i suppose i will have to change my fuel pump as ive heard it dies around that power level on a r33. i was curious as to what pump would do the job should i just get the bosch 044, go a larger in tank replacement pump from GCG??, also i was wondering what those walbro fuel pumps are like?? they are rated at 500hp, so will that do the job for my power level??

Also, i wont need a regulator as well will i as the stock one along with the injectors will still be doing the job well enough right??

any info in helping me get the fuel side of things correct will be appreciated... :)

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/
Share on other sites

walbro will do the job.

but get a bosch as they are cheaper :) unless you get a good price on a walbro that is.

probably for a mild upgrade a Bosch 984 or something.

for only 190rwkw it'll do you fine and dandy

stock reg & stock injectors will be fine for those mods.

take it further you'll need bigger pump/injectors blah blah.

but if your stickn to 190rwkw or so. as above

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/#findComment-958176
Share on other sites

You don't need an 044 pump. I got one and I didn't need one that big, but I got it anyway because it was so cheap. A 910 or 040 should be cheaper and better than a Walbro. The cost will balance out with the work you have to do to fit it, but if you get 550hp out of your Walbro I will give you $5. They rate their pump flow in a dodgy arsed way, with no fuel pressure. Under normal fuel pressure of a Skyline it's more like 400hp. I believe they now have a "high pressure" version, which you should get if you are considering a Walbro. The old model will not get you much more power than stock. Which is ok if your old pump is dying or dead anyway, but I would want to pay less than $300 for it.

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/#findComment-959940
Share on other sites

While were on the topic of fuel pumps is it just me or do other people notice that their cars seem to have more power after filling up? As opposed to 1/4 or 1/2 a tank.

I noticed this when my car had both 145 & 185 at the wheels.

Is it likely the factory fuel pump is struggling when low, or stale week old fuel, or just more weight in the back giving more downforce pressure/traction?

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/#findComment-959979
Share on other sites

While were on the topic of fuel pumps is it just me or do other people notice that their cars seem to have more power after filling up? As opposed to 1/4 or 1/2 a tank.

 

I noticed this when my car had both 145 & 185 at the wheels.

 

Is it likely the factory fuel pump is struggling when low, or stale week old fuel, or just more weight in the back giving more downforce pressure/traction?

...good question... anyone care to enlighten us?

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/#findComment-959989
Share on other sites

If your fuel pump does struggle then you risk knock in the engine. If it does sense knock I'm pretty sure it will retard power. I know it does in mine but I run a Power FC. Not sure what the stock ECU does. Maybe if you have a fuel pickup problem it might be running low on power but I'd be more worried about the engine knock. You should have your AFR looked at to check it out and confirm.

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/#findComment-959998
Share on other sites

If your fuel pump does struggle then you risk knock in the engine. If it does sense knock I'm pretty sure it will retard power. I know it does in mine but I run a Power FC. Not sure what the stock ECU does.

If you have a standard PowerFC then it doesn't retard the timing with a high knock. The standard ECU does retard the timing.

Link to comment
https://www.sau.com.au/forums/topic/47419-fuel-pumps/#findComment-960615
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Personal experience. Those f**kers burn. And are actually a PITA to put out. Next time I walk down the back, I'll snap a photo of what the inside of the bonnet looks like when that thing ignites. PS, powder fire extinguishers are useless on that stuff too as it's fibrous and when it ignites, it starts to pull apart. And you end up just blowing powder through a sieve effectively.   Like the big thing is, if it's fire resistant, it's job is to stop what burning? The METAL above it? It's just to try keep heat off the bonnet paint work.
    • Oh man, sorry, $60.00000000... 😛
    • That's more or less what he meant. What it really means is that you do not have to go full crazy on the build. Don't need the best oil pump, expensive rods & pistons, big cams, etc. You can upgrade whatever you want instead of using stock level items, but you don't have to. Having said that - any time an RB is opened up, if anything is getting replaced, I think the opportunity should be taken to do all the sensible upgrades. Pistons, rods, pump, etc.
    • February update 🙂 We managed to get the very last 1/18th "Extra Scale" cars stock available from bookstores in Kyoto. These are actually the last ones and will not be restocked again! Hachette Collections Japan have not decided on a release date for these or other models in the series, so for the time being these are all there are available new.  These are showing up on Yahoo auctions at inflated prices already (especially the Celica and NSX) so get yours now at a very reasonable price before they disappear! Stock quantities: NA1 Honda NSX - 1 left: https://www.oemsoko.co.jp/products/1-18-extra-scale-1990-na1-honda-nsx 1973 Toyota Celica LB 2000GT - 2 left: https://www.oemsoko.co.jp/products/1-18-extra-scale-1973-toyota-celica-lb-2000gt 1968 Mazda Cosmo Sport - 2 left: https://www.oemsoko.co.jp/products/1-18-extra-scale-1968-mazda-cosmo-sport 1970 KPGC10 Nissan Skyline 2000GT-R - 2 left: https://www.oemsoko.co.jp/products/1-18-extra-scale-1970-kpgc10-nissan-skyline-2000gt-r
    • When you say basic rebuild, you mean an oem rebuild?
×
×
  • Create New...