Jump to content
SAU Community

Recommended Posts

I have a DC 678 cooler to go on, and have read just about every thread and post on other members setup before asking this question, but there are varying views on installing it before or after the factory rad cooler?

-Should I go before or after?

-Also, any tips on getting the factory aero front bar off?

Edited by Anquetil
Link to comment
https://www.sau.com.au/forums/topic/475916-nm35-transmission-oil-cooler-setup/
Share on other sites

Bypass it all together and buy one of these. I'm setting mine up with one and I know of another guy who has run one of these in the Perth heat. 

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com.au%2Fp%2F1817760421%3Fiid%3D202564437526

24 minutes ago, Sack87 said:

Bypass it all together and buy one of these. I'm setting mine up with one and I know of another guy who has run one of these in the Perth heat. 

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com.au%2Fp%2F1817760421%3Fiid%3D202564437526

Good unit but still fit it after the heat exchanger in the radiator to help trans warm up more quickly from cold. The average trip is only about 10km

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The cam I am actually putting in (a few posts up) is actually smaller than my current one. At least duration/overlap wise. All the chop stuff I hear just sounds like an engine running badly, because it is. I then envision driving it around in 1st gear and being massively sad about it bucking to the beat of said chop. There is an idle video of someone with a similar cam floating around the internet, but mine is a custom cam (so is his) so it'll never be the same, plus the fact exhausts are entirely different. What I want to do is put some bullet mufflers/race mufflers in to replace a couple sections straight pipes that currently replace the two extra cats that I don't need. But this is even further down the line!
    • I can tell you now, when the bracket that the little hydraulic ram attaches to snaps, with a subframe, and V8 from an AMG C63 on it, it sounds like someone letting shotgun off right beside you. It leaves your ears ringing, and a huge thankfulness that you never ever put a body part under something heavy that's only supported by a hydraulic lift...
    • Still not a guarantee fix. I used a high quality butyl-mastiq (the black goo that's not really silicone nor polyurethane, same stuff they use from the factory that just spreads out like melty cheese), and I still get lots of water on both sides of the trunk when raining or washing the car. I also suspect the factory spoiler rubber gasket might not be sealing well, so I'm thinking of adding a thin layer of grey silicone around the bolt holes on both sides and see if that's where it also leaks from. The biggest issue is that these cars don't come with a drain hole on each side like other coupes and hatchbacks.
    • I hate it, but maybe he could paint it Monster jam style and call it...godzilla?
    • Would seem to me to be appropriate to go GTR style bar. There are options with and without N1 vent holes, with the GTR lower lip integral (because FG copy). https://justjap.com/search?q=r32 bumper  
×
×
  • Create New...