HELP on Atessa!

[GTR33Vspec]

My GTR33 V Spec LM has been running on 2 wheels and car is in workshop for 4 months!

My girl has ABS light, A LSD light on and has been running rear wheel.

G sensor replaced and lights went off .. only just for a moment... light came on after that and even after small run of 3km.

I have attached a photo of error code from ECU #35 and #37.

please shed me some lights troubleshooting this and all wire, sensor, motor, solenoid , ECU checked.

 

[GTSBoy]

Um. It tells you right there on the diagnostic tool that your ATESSA solenoid is borked.

[dr phil]

If that description against code 37 is correct, it would mean that the ETS solenoid circuit is open, which could mean plug not on properly, wiring broken etc, as well as a possible problem with the solenoid itself. I could probably dig out diagnostic steps for that issue if you want, would be things like check resistance across solenoid when unplugged, try reseating the plug, then check for broken wiring between solenoid and control unit I’d suspect.

[GTR33Vspec]

Yes, Dr Phil please help to dig more info so we can put focus on where to start... currently we took off the motor and suspect the motor is not running 

[GTSBoy]

Well it's not running now....

[dr phil]

This is from the R34 manual, so you will need to be careful as the plug pinouts may be different to R33. But, it does show what resistance to expect across the various solenoids, and pressure sensors / switches. Also - it says you test the motor with 12v for less than 5s.

[I gotta R34gtr v-spec]

u can activate the pump by i think shorting out the small plug under the dash which is done to bleed the system,i'll have to drag the manual out ?