Jump to content
SAU Community

Recommended Posts

PT1

I recently purchased my first Skyline and the owner stated that they had done the HICAS delete. I am unsure what path they took, but I have the dash light on AND he claims to have utilized a Pathfinder power steering pump. I read through the various HICAS posts and saw lots of good ideas,  but I did not see this listed as one of them. Has anyone had any experience with this? I got the car and the belt was splitting, I used the part number from the belt to replace it (the belt looked relatively new). Now, the second belt has shredded in less than a week. The pump has a standard tensioner with a grooved track, one long bolt that adjusts tension, and another bolt that locks it in place on the track and provides minimal in and out adjustment. Everything looks ok, but clearly if I am eating belts there is an issue. What I have noticed on both instances, is that the belt splits directly down the middle; I am unsure what this is indicative of.

 

PT2

Will it hurt the power steering rack if I drive it without power steering? My temporary solution has just been to drive it manually, sans belt. 

Cannot comment on Pathfinder pump.  But realistically, so long as the pump places the pulley in the right spot, just about any pump will do.

HICAS "delete" does not imply that the HICAS warning light will not illuminate.  If you do it wrongly, you will get the code.  The HICAS CU is responsible for providing your variable rate power steering.  Therefore, to retain this, you must retain the CU.  If you remove the remainder of the HICAS system (actuators, sensors, etc) then it will chuck the shits and throw up the warning light.  The solution to this problem is to leave the larger of the two connectors attached to the back of the HICAS CU and disconnect the smaller of the two.  The important parts of the HICAS will still do their job, but no dash light.  Or, you just remove the bulb from behind the dash.  The plug is easier.

Yes, you can drive without power steering.  It is much much harder work, especially at parking speeds, but it actually feels nice on the move.

Assuming that the Pathfinder pump is incorrect in some way, you should obtain an early RB25 PS pump as an easier approach to making sure that the pump will line up with the other pulleys on the engine.  Or, you can just put an original R32 PS pump back on it and use the rear stage of the pump to run a separate PS cooling loop.

Ok, I was most concerned about running the power steering “de powered” I know some cars are sensitive about that. 

The dash light I was referring to more as I thought it was evidence of some kind of HICAS work. I will follow up with the previous owner and see if he can explain what all has been done.

HOPEFULLY, I won’t have to purchase any extra parts, but we shall see. The other options are certainly easier; I would just rather spend the money on fun stuff. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • How old is the battery, it's more likely your battery is on its way out.
    • I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...