Jump to content
SAU Community

Power fc tuning E85/98


AngryRB
 Share

Recommended Posts

I've been running E85 tuned on the power fc and had cold start problems for a long time which are apparently caused by dirty injectors.

So is it possible to fill with 98 and run a tank just cruising on light throttle with some reduction made on the hand controller or do i need a laptop and software and a 98 tune to switch to?

I read on here that a tank of 98 every few tanks will keep the fuel system clean.

Link to comment
Share on other sites

Your cold start problem is probably down to the tune...or if you have dirty injectors take them out and get them tested and cleaned. If they are dirty you will fix the problem . If they are not try the tune.

Link to comment
Share on other sites

1 hour ago, GTSBoy said:

It will be hella lean and way too advanced on 98 at any throttle above 15%.

You mean hella rich?

Best way is to have 2x tunes, ghetto way is to blend up some E40 or so and run that with temporary injector correction so it runs okay on light throttle, cruise, etc.

If you've been having cold start issues from the start, it's more likely you don't haven't enough cranking fuel for when it's cold.

Link to comment
Share on other sites

Tuner says injectors are dirty as he replaced Cas, coils , coil loom, fuel reg, fuel filter and then road tuned it and did a week of cold starts.

It starts up quick when cold and hot, but when cold cyl 4 and 5 are dead until i get load into it in say 3rd which is a rough cold start, then is like it clears its throat and  back on all 6 cylinders. 

Seems that the injectors are only dirty temporarily so not sure getting them cleaned will help for long but worth a try.

 

Link to comment
Share on other sites

If you have long term cold start issues which are caused by injectors which are blocked up enough to make it drop cylinders then I would have serious concerns about your engine health by now.   If you have been using the power you have and haven't hurt your engine then you are either quite lucky, or the dropping cylinders while in the warm up cycle is more likely to be a tune issue than "blocked injectors which magically clean up when the engine is warm, only to freshly block up again when it gets cold".

 

:35_thinking:

 

  • Like 1
Link to comment
Share on other sites

Sticky injectors that won't move until they've got a little heat into them is a possibility.  But otherwise, I concur with Lith.  You have some cause to be worried about your engine.  The earlier advice ref pulling them out and having them cleaned properly is the only sensible choice you have here.

Link to comment
Share on other sites

4 hours ago, Lithium said:

If you have long term cold start issues which are caused by injectors which are blocked up enough to make it drop cylinders then I would have serious concerns about your engine health by now.   If you have been using the power you have and haven't hurt your engine then you are either quite lucky, or the dropping cylinders while in the warm up cycle is more likely to be a tune issue than "blocked injectors which magically clean up when the engine is warm, only to freshly block up again when it gets cold".

 

:35_thinking:

 

I pulled plugs out and did comp test to see, maybe number 6 has been affected.

The 155 annoys my OCD tendency, i will test that 10 more times lol ?

20190327_122421.jpg

Edited by AngryRB
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • From there, as the manual says....assembly is the reverse of disassembly, no tricks worth mentioning Much better (for me)
    • In my case, the standard wheel I had was in good condition but the buttons had more wear, so I swapped them across from the original wheel from the car. The plastic rear cover is held on by 4 tabs, and once the wiring is removed you can get access to 2 screws on each side the hold the buttons in From there I just swapped the wiring over. What was interesting is the standard style wheel is 2.0kg but the carbon fibre one is 50% heavier at 2.9kg. It even has a weight inside the wheel at the top to make up for some sort of imbalance in the design. weird
    • Once the airbag is off, to remove the steering wheel.... Undo the 2 plugs into the clock spring, and the horn connector from it's clip. Hit the 19mm nut with a rattle gun (preferably) or if you don't' have one, you probably want an assistant to hold the wheel in place while you use a breaker bar to undo the nut Then, screw the nut back on 3 turns, and pull the wheel sharply towards you. If that doesn't work hit it medium force with a rubber mallet on either side, or possible behind if you can get there. If that all fails (it shouldn't!) you might need a steering wheel puller
    • So, to next task....the carbon fibre steering wheel was either an expensive factory option or a chinesium special. Either way, I don't like either the flat bottom or thick ring style, so it had to go So...to remove the steering wheel.... First, disconnect battery negative and stomp on the brake pedal for a few seconds. Then, remove the small circular covers on each side of the wheel's rear surround to uncover the airbag clips. You need to push something like a flat bladed screw driver through, to push the steel clip inwards and pull the side of the airbag forward. Once you've done the easy side, same on the centre console side. You can see the tab you are shooting for circled in red Then, disconnect the horn spade connector and for the yellow airbag plug you need to get something small under the black locking tab to pop it out, then the connector releases......airbag is off  
    • @99RS4just wondering if you ever took photos of the footwell lighting / how you bypassed the controller, im keen to haver footwell lighting come on when I open the doors too   
×
×
  • Create New...