Jump to content
SAU Community

Recommended Posts

was wondering in the stagea would be capable of towing a old 521 datsun ute, total weight would be about 1600-1700kg inlcuding a trailer, with hills, because new zealand, these are a couple photos of the tow bar and mount, the mounts go either side of the spare wheel to the rails, asking as the rating sticker has been faded but at a guess it would be only 1200kg from what i have read on here

55957808_348464929209644_4394163774769070080_n.jpg

56398397_440365256524713_1221720541317038080_n.jpg

56618801_367507387190466_3276571541562720256_n.jpg

Edited by darksould43
Link to comment
https://www.sau.com.au/forums/topic/476518-towing-a-datsun-with-stagea-m35/
Share on other sites

Any brakes on the trailer? I haven't had a look under the back of an M35 but from other posts it seems you need to be very careful to reinforce places where you bolt the tow bar up. I would take the risk,   driving very carefully,  but be aware of the potential weakness.

6 hours ago, KiwiRS4T said:

Any brakes on the trailer? I haven't had a look under the back of an M35 but from other posts it seems you need to be very careful to reinforce places where you bolt the tow bar up. I would take the risk,   driving very carefully,  but be aware of the potential weakness.

Yes trailer brakes 

10 hours ago, KiwiRS4T said:

Any brakes on the trailer? I haven't had a look under the back of an M35 but from other posts it seems you need to be very careful to reinforce places where you bolt the tow bar up. I would take the risk,   driving very carefully,  but be aware of the potential weakness.

Exactly what I would do too, assuming its's also not too far (or if it is, regular stop and looks). But I'm no engineer or NZ road law expert

6 hours ago, Duncan said:

Exactly what I would do too, assuming its's also not too far (or if it is, regular stop and looks). But I'm no engineer or NZ road law expert

It is a distance, close to 4 hours, 300 km, couple hills, and I would stop every now and then to let it cool down 

It's no so much the cooling down as it is the brakes, the strength of the chassis (which will stretch if pulling more load than it can handle, especially uphill).

Just rolling along for hundreds of km at a steady speed won't cause any grief at all, except with the coppers if they decide you look like you belong on Highway Patrol.

30 minutes ago, GTSBoy said:

It's no so much the cooling down as it is the brakes, the strength of the chassis (which will stretch if pulling more load than it can handle, especially uphill).

Just rolling along for hundreds of km at a steady speed won't cause any grief at all, except with the coppers if they decide you look like you belong on Highway Patrol.

well ill keep that in mind, there maybe routes to take without hills, thought the hills arent massive ones either

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I replaced the whole clutch line with the chase bays braided hose, I think it removes that loop, is it the short hose that comes immediately off the slave or is there a drawing in the manual to find what you’re referring to? It was just re-bled when I upgraded to the nismo slave, old slave worked fine but I thought that might help, didn’t change a thing. It’s like the first half of the pedal is pushing air and then when it finally actuates the master the friction zone is tiny. Makes it practically impossible to launch the car
    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
    • I would agree, unless you need something specific to the HV motor/battery side repaired or investigated, any mechanic will be able to perform normal services, but if you prefer, maybe look for a mechanic who regularly services/repairs Nissans, the VQ engines are pretty common in the Nissan lineup.  Sorry, I can't make any suggestions, I don't live in Vic.
×
×
  • Create New...