Jump to content
SAU Community

Toyota 86 BRZ X FORCE 2.5" CAT BACK

The Bogan
 Share

Recommended Posts

The Bogan Grand Master

The Bogan

Posted
Posted

Used  12 months old

"Slighlty" louder than stock

$250

Reason for sale: after going full decat exhaust was to loud, so I replaced my OEM cat back to tone it down a bit

Pick up only

Located at Holsworthy 2173

Cheers

20190523_202559.jpg

20190523_202545.jpg

Link to comment
https://www.sau.com.au/forums/topic/477128-toyota-86-brz-x-force-25-cat-back/
Share on other sites
The Bogan Grand Master

The Bogan

Posted
  • Author
Posted

100 cell front pipe

$100

This and the X Force cat back give a car with the OEM header a good sound.

This complete setup with a catless header is as loud as balls on start up, and regular loud once warm.

20190524_114739.jpg

The Bogan Grand Master

The Bogan

Posted
  • Author
Posted

Will take a $100 off the price if you can supply good OEM front pipe, will take $250 off if you can supply a whole OEM exhaust system (Front pipe back).

Must be in good order.

Basically your OEM exhaust + $50 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Bargain.

The Bogan Grand Master

The Bogan

Posted
  • Author
Posted

 happier pricing

Your excellent condition OEM overpipe back full exhaust (front pipe, mid pipe, axleback) + 6 pack of Jack Daniels and cola for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super happy fun slide price.

Your OEM front pipe + $150 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super happy price

$250 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super price

The Bogan Grand Master

The Bogan

Posted
  • Author
Posted
On 30/05/2019 at 5:09 PM, mlr said:

 happier pricing

Your excellent condition OEM overpipe back full exhaust (front pipe, mid pipe, axleback) + 6 pack of Jack Daniels and cola for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super happy fun slide price.

Your OEM front pipe + $150 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super happy price

$250 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super price

 More happier pricing

Your excellent condition OEM overpipe back full exhaust (front pipe, mid pipe, axleback) + 6 pack of Jack Daniels and cola for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super happy fun slide price.

Your OEM front pipe + $100 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super happy price

$200 for X Force 2.5" 100cell front pipe and 2.5" resonated cat back.

Super duper price

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      R34 Gtt Wheel Offset Advice

      By GTSBoy · Posted

      What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • silviaz
      R34 GTT idle problem

      By silviaz · Posted

      I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • Kinkstaah
      R34 Gtt Wheel Offset Advice

      By Kinkstaah · Posted

      This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • AdiR34
      R34 Gtt Wheel Offset Advice

      By AdiR34 · Posted

      Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...