Jump to content
SAU Community

Recommended Posts

Hey guys. So I’ve recently brought a 2001 m35 with the vq25det.  And slowly a few issues are appearing. 
 

first off. This morning when I went to start it, it just wound over for a lot longer then usual. Then once started it smelt strongly of petrol. Any ideas? Had started and run fin since. 
 

 2nd. 
I have a shudder in the driveline. I have read a bit on here and think it may be the driveshaft uni to the front. My question is, would this cause, 

a shudder when reversing and turning but not when in a straight line, a shudder under heavy acceleration, and a very slight shudder at around 100km/ph which goes away if I touch the gas. I also noticed that the front Torque gauge bounced with the shudder. 
 

im unsure if shudders the right description or more of a rhythmic binding of something. I also have a groan that sounds like wheel bearing but they all appear fine, could this be related? 

sorry for the massive post but have researched about as much as I can already, all help and advise is appreciated massively! 

 

Link to comment
https://www.sau.com.au/forums/topic/478870-m35-issues/
Share on other sites

On 10/9/2019 at 9:58 AM, LMo13 said:

If really cold and left outside over night, I've had mine fail to start on first try. The smell of petrol could be a flood of left over fuel from cranking and failing to kick over.

 

RE: the shudder - Do you have aftermarket wheels?

Was no colder then normal on this morning. i did suspect that was the fuel smell but thought it was worth mentioning.

 

yes aftermarket wheels. Same size all round. 

Link to comment
https://www.sau.com.au/forums/topic/478870-m35-issues/#findComment-7917502
Share on other sites

Check the Attessa reservoir level and then bleed the system at he rear pump and behind the gearbox.

Drop the front driveshaft. Its just four bolts and the car will work fine without it (in RWD of course).

Then you can check the universals for play

Link to comment
https://www.sau.com.au/forums/topic/478870-m35-issues/#findComment-7917520
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The cam I am actually putting in (a few posts up) is actually smaller than my current one. At least duration/overlap wise. All the chop stuff I hear just sounds like an engine running badly, because it is. I then envision driving it around in 1st gear and being massively sad about it bucking to the beat of said chop. There is an idle video of someone with a similar cam floating around the internet, but mine is a custom cam (so is his) so it'll never be the same, plus the fact exhausts are entirely different. What I want to do is put some bullet mufflers/race mufflers in to replace a couple sections straight pipes that currently replace the two extra cats that I don't need. But this is even further down the line!
    • I can tell you now, when the bracket that the little hydraulic ram attaches to snaps, with a subframe, and V8 from an AMG C63 on it, it sounds like someone letting shotgun off right beside you. It leaves your ears ringing, and a huge thankfulness that you never ever put a body part under something heavy that's only supported by a hydraulic lift...
    • Still not a guarantee fix. I used a high quality butyl-mastiq (the black goo that's not really silicone nor polyurethane, same stuff they use from the factory that just spreads out like melty cheese), and I still get lots of water on both sides of the trunk when raining or washing the car. I also suspect the factory spoiler rubber gasket might not be sealing well, so I'm thinking of adding a thin layer of grey silicone around the bolt holes on both sides and see if that's where it also leaks from. The biggest issue is that these cars don't come with a drain hole on each side like other coupes and hatchbacks.
    • I hate it, but maybe he could paint it Monster jam style and call it...godzilla?
    • Would seem to me to be appropriate to go GTR style bar. There are options with and without N1 vent holes, with the GTR lower lip integral (because FG copy). https://justjap.com/search?q=r32 bumper  
×
×
  • Create New...