Jump to content
SAU Community

Recommended Posts

Has anyone else experienced a jump in their odometer after their battery went flat?

And is there anything that can be done other than replacing the meter with one that has roughly the same mileage?

Is this a car with an electronic odometer or a mechanical one? 

If it's electronic, you could have suffered from a rollback situation, if it's mechanical i'd lean more toward a failing odometer than anything else. 

I presume this is a r34 gtt so sounds like a faulty instrument cluster. The mileage is stored in an eprom which is non volatile memory, so a dead battery would not cause this.

Edited by NZ-GTT
  • Like 1

Yup the car's a 34 GTT. Hope it's not a sign of the instrument cluster being on the verge of failure. 

But then again, if it did I'd have an excuse to put in the Nismo 300kph ones ?

Cheers guys

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So there is no other way to remove and install the ball joints then to buy the Frenchys kit?
    • Just to close off this post with the cause of my oil consumption issues. Vertical scoring and glazing at the bottom of cylinder 6. I'm not happy, but at least I finally found something. I'll pull it and get it apart asap. Hopefully I don't need to go one size up in piston. 
    • I finally got around to purchasing an actual articulating borescope. Great tool to have, I've been very impressed vs my old regular inspection camera.  With that being said, sadly I finally found the cause for my oil consumption. I always had the feeling something wasn't right but compression and leak down tests were always perfect and I had already inspected the cylinders. This time i dropped each cylinder to its absolute lowest point and with the better quality camera I found this... Bottom of cylinder 6.  Scoring looks deep and I'm presuming oil getting by caused the glazing. I already spoke with my assembler, and will be dropping it off as soon as I can pull the motor and get it apart. I'm just hoping it's not deep enough to require boring out from 86.5 ->87mm. Pistons aren't cheap. 
    • I think it's the same. It all comes from the same shithole refinieries in SE Asia.
    • I was referring to the final octane level achieved once 10% ratio of ethanol is added.
×
×
  • Create New...