Jump to content
SAU Community

Recommended Posts

Don't worry about the shifting guide. You can change up at any speed between idle and redline. The only question after that is whether it will have enough torque to swallow much throttle opening in the next gear> RB20s have little torque, so the answer to that question will be "no" unless you're above about 3k rpm. And just to the right of the speedo is the gauge that will tell you about that.

The km to mile conversions are correct enough. Everyone since forever has treated the conversion as 40=60, 50=80, 60=100 and 70=110, to within the accuracy that matters.

For efficiency shift based on the peak efficiency RPM, shift just past the peak efficiency point while maximizing load without encountering high load enrichment so you sweep through the efficiency sweet spot. Looking at the gearing of the GTRs it looks like you want to be shifting at 3000 RPM so you drop down to ~2000 RPM when accelerating. Hold the engine right around 50-60% throttle if this is an NA engine or right at atmospheric pressure for turbo engines for best results.

For cruising pick the highest gear that doesn't have you exceeding the accelerating throttle condition. As for the best speed to cruise at, something high enough that you aren't running below 2000 RPM and something low enough that you don't exceed 3000 RPM.

  • Like 1
3 minutes ago, joshuaho96 said:

It's simple, it's the condition where you are accelerating with the throttle.

How do you accelerate without using the throttle... unless rolling down a hill? ?

3 minutes ago, Piggaz said:

How do you accelerate without using the throttle... unless rolling down a hill? ?

Very carefully?

Jokes aside the point is that lugging the engine at 1500 RPM and WOT to cruise is going to actually be quite inefficient even if the pumping loss is minimized. It's better to cruise at 2500 RPM with less throttle. The exact numbers are going to vary by engine but the principle is the same.

1 hour ago, joshuaho96 said:

Very carefully?

Jokes aside the point is that lugging the engine at 1500 RPM and WOT to cruise is going to actually be quite inefficient even if the pumping loss is minimized. It's better to cruise at 2500 RPM with less throttle. The exact numbers are going to vary by engine but the principle is the same.

Can you explain how you came to this conclusion? 

I am interested in the math and any other data you are relying on to make this statement. 

  • Haha 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Whoa, that's a name I've not see for a long time! Sorry to hear about the engine / turbo damage.  Fwiw with any engine problems it often really a case of just seeing what happens when it's apart, ymmv - I wouldn't rule out the possibility that the damage isn't even from the turbo failure, or possibly from a combination.  The airflow between cylinders isn't dead even, injectors can go off over time as well, with the turbos overboosting if you didn't have upgraded fuel system there could have possibly been a bit of leaning out - stock triggering is often a bit unreliable by this age too.  Basically its an old engine and a few things could have been going on, and you won't know how much work is needed until the engine is apart.  
    • I'm just shocked there's a euro driver on our roads who is thinking of other road users and not attempting to blind everyone. I wonder if Prank uses his indicator too...
    • Its hard to tell really. The Q50 owner's forum talks about it a lot and has quite a few people directly affected, but no idea what % of cars sold actually had the block replaced. Also, there seem to be 2 distinct issues which both get diagnosed by Infiniti as requiring a block replacement (no wonder they are going broke) 1. "Porous block" where coolant mixes with oil through thin or poorly cast parts of the block 2. Head coolant gallery plugs not sealing. If I was noticing engine coolant loss I'd start with cooling system pressure test (as always) and then I'd pull the cam covers and reseal the coolant gallery plugs on both side before worrying about a potentially porous block.  If neither of those did the trick it would be put in a second hand engine out of japan; I haven't checked pricing but I'm sure there are plenty around by now as they've been in production 10+ years
    • To clarify what I posted above, I thought you both had a situation where it cancelled sooner one way than the other.....if it is reasonably even where it cancels in either direction that is probably normal (consider gentle movements like lane changes, you don't want it to need half a turn of lock to turn the indicators off)
    • Son, in this country, that is a piece of Gyprock. f**king drywall. FFS! I also like the autocorrect of trailer to tablet. I was reading it and thing, "what the hell drugs is he on?" Then the photo made it clear enough.
×
×
  • Create New...