Rb25det ski boat

[Bluejinx]

Ok, so the engine has been fit for measurements of sump etc and its back out again now. Any advice for the dry sump inlet to the block? I was going to feed it in where the oil pump feed oil into the block but it looks pretty small? Should I be removing the oil filter stud and put a fitting directly in there?

[Dose Pipe Sutututu]

That's awesome!

Anyhow I don't have any dry sump experience, however you did mention using the filter stud for oil.. you could piss off the entire oil/water exchanger and use this

http://www.kudosmotorsports.com/catalog/distribution-block-suit-nissan-p-2157.html

[Bluejinx]

Working on dry so placement today. Should be able to get the belts mostly under the floor.

[Bluejinx]

Pulley drives completed today

[Bluejinx]

Update time.. engine is built and mounted. GTR rods, ARP bolts, stock pistons, new rings, honed, all surfaces machined and new OEM gaskets. Turbo is a gt 3576r wonder if it'll be too big for this thing? Engine is now dry dumped and 1000cc injectors now fitted, powerfc ecu is in a box on the bench.