Jump to content
SAU Community

Recommended Posts

Hello All,

My engine is being mildly built at the moment and want to address the oil setup. I am thinking of doing a 2stage wet sump pump setup, one feed and the other scavenge. 

The scavenge I want to use from the back of the head drain to assist in getting the oil back down to the sump. Anyone see any issues with this setup? I'll be buying the 2 stage pump from Aviaid.

Thanks,

Brian 

Link to comment
https://www.sau.com.au/forums/topic/482740-2-stage-aviaid-wet-sump-opinions/
Share on other sites

You can have scavenge pumps with a wet sump, there are a number of production cars that have a wet sump with a scavenge pump. As for where you put the scavenge pump I would imagine you would want to pump oil primarily, so it would end up being somewhere like the turbo drains or an engine block drain somehow. The "head drain" is really more breather than oil drain, although the distinction gets a bit wibbly wobbly in cases where oil is getting stuck in the head due to excess crankcase pressure.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Diagnosing with and without is mostly the same. You need to know, as Duncan asked, and what conditions. Car hot, cold, idling, driving, if while driving what rpms, is when you're varying, or is it when held constant.   From there it's understanding what can be causing it. Starting with pretending all of the sensors are correct. Which means if it's going rich, why would it be thinking more air is going in than it is, and under what conditions. So things like if only when under boost, it could be be a loose intake piping joint. It's just understanding the system, and understanding when/how the problem occurs, and then if it's only occuring in specific scenarios, what can be causing it.   ECU specifically, if it's aftermarket, it'll have software you can use, for the Skylines on factory ECU, there is Nissan Consult you can use. Most ECUs have a way to get data from them.
    • How do you go about diagnosing ecu's that don't have data logging, is it more experience at that point and just trying out things that you think will fix the issue?
    • Stock O2 are basically useless beyond anything at stoich. Any misfire will also be seen as lean. The stock O2 also read a collective exhaust gas volume, not each cylinder. Sputtering and missing means not each cycle is firing, and some are. Which means even if rich, as shit, on cylinders as they miss, they'll read lean, but the cylinders that did fire will read rich, and combined, well, they can read anything from rich to lean.   Start with the basics before even going looking at sensor values.   Edit: I say the above, and that's coming from the guy with a few thousand dollars worth of scan tools sitting right beside me right now that I use frequently for my job.
    • I just finished up a manual swap and I have a 1999 S2 AWD automatic in my garage, depending on where you are located. I'm in the the midwest of the US.
    • I’ve heard it can be done, you need to redrill the holes where they bolt to the chassis and apart from that they are the same. I’ve never done it or know anyone personally that has, it’s just something I’ve heard 
×
×
  • Create New...