Jump to content
SAU Community

Recommended Posts

On 5/17/2022 at 5:25 AM, TXSquirrel said:

Sounds like new aftermarket exhaust and a set of proper Michelins and it's all set.

Some people seem to be dumping on this car really hard but to me this is basically a brand new Z32 with nearly zero mods needed to make it into a really good car. SavageGeese has said this EPS rack is actually better than the old 370Z hydraulic rack in feel and feedback. It's probably not going to feel as good as a good hydraulic rack like an R32 but you'll never have to deal with the rack seeping fluid from every line and seal as it ages either.

On 5/17/2022 at 6:58 PM, BK said:

What Bride seat ?

I'm about 194cm. I have Bride Brix 2 seats on Bride MO superlow rails in the blue 32 GTR which substantially drop the height from normal, and the 32 sucks badly compared to my 33 - I have the seat all the way back too.

I am a 190cm fatty and went with a Stradia 2 XL low max in my v35. I get much more head room (especially if i remove the cushon shown in the photo, then even a helmet is comfortable and not touching the roof). It is not as comfortable as the stock seats, the bolstering makes my hip sore on long trips :(

If the new Z's had roughly the same space as a 350z i would get one, but sounds like i will be out of luck fitting into it :(

20210503_132636.jpg

Edited by SomeFReaK
  • 11 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh... literally every time i jump on a forum, see an instagram post or see an engine bay at a car show, i get an idea and add it to my 'to do' list. So what started off as, hey can u just make a couple of intake hard pipes because my dumbass bought the wrong apexi kit, blew out into a 2 week job including braided brake lines & custom bash kit for the front lip haha.  Getting Luke from A4E engineering to make a full custom exhaust with a controllable aes dump valve so i can actually switch between quiet and loud, because right now its just loud all day every day. Then after that go and get the tune redone flex e85 & 98 as i get bugger all milage from e85, makes going for longer drivers difficult
    • Car looks clean as. You ended up getting quite a bit done 😂  So what's the plan for the exhaust? 
    • The only Neo rods that were any different to any other RB25 rods were the DET ones, and they were the same as RB26. Here is a Neo DET rod. O5U part number visible. Here is a post in a thread here on SAU with evidence from someone who has done this before. There are photos in the thread of normal RB25 rods.  
    • Sure, but why assume that will be the case forever? And why assume you'll be able to do an oil change to swap back to a stock drain bolt before that happens? And does it even matter when I change the oil at fairly short intervals? Life can be funny sometimes and unexpected things can happen. Like breaking a collarbone so you can't do any work on your car for a few months but the oil change is due so you have to take it to somewhere and hope they don't do something stupid like stacking the new drain plug washer on top of the old one.
    • Do u know how to identify the rods are rb25 or neo ones? Can u look into the pics and tell me is they de or de neo ones. Its confusing becoz my motor has de neo head but block is 25de 75t, so really confusing me about rods, crank.
×
×
  • Create New...